Fisher & Paykel DD90SDFTM2, DD90SDF(H)TX2 manual Badge zone

Page 20


		INTEGRATED MODELS WITH BADGE (GB IE) ONLY - INSTALLING THE FRONT PANEL & BADGE CONTROLS		20


15b DETERMINE BADGE CUTOUT LOCATION			16b REMOVE BRACKET & DISCONNECT BADGE

WARNING!

Electrical Shock Hazard

Before continuing, ensure that the product is disconnected from the power supply.

Failure to follow this warning may result in electrical shock, injury or fire.

127mm

255 mm

30 mm	25 mm

Badge zone

457
69	mm
	mm

3

1

2

1

4

17b ROUTE BADGE WIRING THROUGH PANEL	18b ATTACH PANEL TO PANEL BRACKET
	Important!
	Use all 14 screws provided as shown.	2
		2
	1	16 mm
	1	x14

1

	Align bottom of panel
2	with bottom of bracket
2

Image 20

Contents Installation Instructions Follow the Installation Sequence Relevant to Your Model DD90SDFHTX2 DD90SDFTM22a Safety and Warnings ALL Models 2b Additional Safety and Warnings Integrated Models only3a Parts Supplied ALL Models Optional3b Additional Parts Supplied with Integrated Models Attached to productProduct Dimensions PlanCabinetry Dimensions Cabinetry dimensions mmFront Panel Specifications Min mm ventilation gap 7a Cavity Preparation Water ConnectionShelf cutouts Maximum Distance of Hoses & Cord from Chassis Edge Left hand sidePage NOW Choose Which Installation Method a or b 9a Attach Side Mounting Brackets11a Pull Through Hoses & Move Into the Cavity 12a Secure the Drawer9b Integrated Models with Remote NZ AU only 10b Pull Through Hoses & Move Into the Cavity11b Remove the Drawer 12b Secure the Drawer to the Cabinetry 13b Refit the Drawer Onto the RunnersX14 17a Earth the Panel 18a Attach Panel to Product Badge zone When refitting Adjust Panel Height to Align the Cabinetry Gaps Connect Inlet Hose to Cold Water 24 Plug Product To required heightFinal Checklist Troubleshooting