Fisher & Paykel DD90SDFTM2, DD90SDF(H)TX2 manual Adjust Panel Height to Align the Cabinetry Gaps

Page 22

21 ADJUST PANEL HEIGHT TO ALIGN THE CABINETRY GAPS	22

Insert an appropriately sized Philips screwdriver into the hole above the door pin and rotate the panel up or down to align the gaps in your cabinetry.

Repeat on the other side if necessary.

The panel has a maximum travel of 2 mm up or down.

+ or - 2 mm

Important!

Integrated models with remote control:

Ensure that you maintain a minimum of 2 mm ventilation gap below the panel.

Designer models and Integrated models with badge: Ensure that you maintain a minimum of 8 mm ventilation gap below the panel.

Image 22

Contents Installation Instructions Follow the Installation Sequence Relevant to Your Model DD90SDFHTX2 DD90SDFTM22a Safety and Warnings ALL Models 2b Additional Safety and Warnings Integrated Models only3a Parts Supplied ALL Models Optional3b Additional Parts Supplied with Integrated Models Attached to productProduct Dimensions PlanCabinetry Dimensions Cabinetry dimensions mmFront Panel Specifications Min mm ventilation gap 7a Cavity Preparation Water ConnectionShelf cutouts Maximum Distance of Hoses & Cord from Chassis Edge Left hand sidePage NOW Choose Which Installation Method a or b 9a Attach Side Mounting Brackets11a Pull Through Hoses & Move Into the Cavity 12a Secure the Drawer9b Integrated Models with Remote NZ AU only 10b Pull Through Hoses & Move Into the Cavity11b Remove the Drawer 12b Secure the Drawer to the Cabinetry 13b Refit the Drawer Onto the RunnersX14 17a Earth the Panel 18a Attach Panel to Product Badge zone When refitting Adjust Panel Height to Align the Cabinetry Gaps Connect Inlet Hose to Cold Water 24 Plug Product To required heightFinal Checklist Troubleshooting

21 ADJUST PANEL HEIGHT TO ALIGN THE CABINETRY GAPS