Operating the Dishwasher (continued)
Standard Programs
The wash cycles available in this hidden menu are special wash cycles that may be used to solve special needs in the field.
NOTE: In the Options Step Down Menu you can return to the main menu at any time by pressing the START button.
1.Open the dishwasher door far enough to expose the control panel.
2.Press the ON/OFF button.
3.Press the MENU/OK button seven times to display the screen “STANDARD PROGRAMS”.
4.After the “STANDARD PROGRAMS” screen is displayed, press the + button one time to display available wash cycles. Those cycles are:
·Regular – normal wash cycle.
·Enviro Care – reduces water and energy consumption.
·Glass Care – reduces temperatures to reduce glass damage.
·Extreme Wash - for extremely hard to remove food soils.
5.Press the + or – buttons until the desired wash cycle is displayed.
6.When the desired setting is displayed, press the START button and close the door to begin the cycle.
Starting the Dishwasher
When the correct cycle and options are shown in the display window and you have added detergent and rinse agent as explained in the Adding Detergent and Rinse Agent section of this manual, press the START button and close the door.
After pressing the START button, the display will show the following information:
·“Close the door”.
·Estimated completion time (this estimated time automatically adjusts throughout the cycle based on incoming water temperature and selected options).
·Current cycle name.
·“Return” (allows you to choose another cycle).
Close the dishwasher door. The dishwasher will begin and run until the cycle is complete. When the dishwasher door is closed, the PowerBeam will illuminate and cast a red circle on the floor to indicate the dishwasher is running.
When the cycle ends, the dishwasher will emit an end of cycle tone (five times). The display will briefly show “Clean”. After 5 seconds the dishwasher and the PowerBeam will automatically turn off.
NOTE: To accelerate and enhance drying, open the dishwasher door, pull the top rack a few inches out of the dishwasher, and prop the dishwasher door against the top rack.
Interrupting a cycle
WARNING
SCALD HAZARD: You could be seriously scalded if you open the dishwasher door quickly during a wash or rinse cycle. Do not fully open the dishwasher door for at least 10 seconds or until water noises stop.
Open the dishwasher door far enough to expose the control panel. The display will show:
•“Cancel Program”.
•“Close the door”.
•the remaining cycle time.
•the selected cycle.
•the cycle phase.
To continue the cycle, shut the dishwasher door. The dishwasher will start automatically and continue the selected cycle.
13