Care and Maintenance
(continued)
Check/Clean the Filter System
This dishwasher has a filter system that consists of a Large Object Trap/Cylinder Filter assembly and a Fine Filter. Select models have an additional Micro Filter. The filter system is located on the inside of your dishwasher under the lower rack and is easily accessible.
During normal use, the filter system is
To Remove the Large Object Trap/Cylinder Filter Assembly:
1.Remove the bottom rack.
2.Grasp the assembly as shown in Figure 35 and turn it counterclockwise 1/4 turn.
Figure 35
3.Lift out the assembly as shown in Figure 36.
Figure 36
Large
Object
Trap/
Cylinder
Filter
CAUTION
INJURY HAZARD: The large object trap could contain sharp objects. Do not reach into the large object trap with your fingers.
4.Carefully examine the assembly. If you find debris in the Large Object Trap, turn it
To Remove the Fine Filter and the Micro Filter:
1. Lift the Fine Filter from the dishwasher floor
as shownFigure 37 in Figure
37and flush it clean by holding it under running water.
Fine
Filter
2. Remove the Micro Filter
as shown | Figure 38 | |
in Figure 38 |
| |
and flush |
| |
it clean |
| |
by holding |
| |
it under | Micro | |
running | ||
Filter | ||
water. | ||
|
To reinstall the filter system:
1.Return the Micro Filter (select models) to its installed position.
2.Return the Fine Filter to its installed position.
3.Place the Large Object Trap/Cylinder Filter Assembly into its installed position in the dishwasher floor.
4.Turn the ring handle clockwise 1/4 turn until
it is locked. | Figure 39 |
The arrow |
|
on the ring |
|
handle |
|
and the |
|
arrow on |
|
the Fine |
|
Filter |
|
should |
|
point to |
|
each other, as
shown by the circle in Figure 39.
5.Gently pull the ring handle to ensure that the assembly is locked into place.
18