Thermador KBUDT4275E, KBUIT4275E, KBUIT4855E Electrical Requirements, Recommended Grounding Method

Page 15

If the anti-tip boards are needed, they must be attached to the rear wall studs 80" to 90" (203 to 229 cm) above the floor. See “Install Anti-Tip Boards” for more information.

NOTE: A clearance of ¹⁄₂" (1.3 cm) must be maintained above the top grille in order for the top grille to be removed.

¹⁄₂"

(1.3 cm)

A grounded 3 prong electrical outlet should be placed within 4" (10.2 cm) of the right side cabinets or end panel. See “Electrical Requirements” for additional information.

The water shutoff should be located in the base cabinet on either side of the refrigerator or some other easily accessible area. If the water shutoff valve is not in the cabinets, the plumbing for the water line can come through the floor or the back wall. See “Water Supply Requirements” for more information.

 

80" - 90"

 

 

(203-229 cm)

4"

 

 

 

 

(10.2 cm)

83¹⁄₂" (212.1 cm) min.

 

84³⁄₄" (215 cm) max.

 

to bottom of solid soffit

 

 

 

77"

 

 

(196 cm)

 

A

 

 

Width

 

 

(see chart following)

 

 

 

6"

 

 

(15.2 cm)

 

1"

 

6"

(2.54 cm)

6"

(15.2 cm)

(15.2 cm)

 

24"

 

 

(60.96 cm) min.

 

Model Width A (as shown above)

4241¹⁄₂" (105.4 cm) to 41³⁄₄" (106.1 cm)

4847¹⁄₂" (120.7 cm) to 47³⁄₄" (121.3 cm)

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection.

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.

IMPORTANT: If this product is connected to a GFCI (Ground Fault Circuit Interrupter) protected outlet, nuisance tripping of the power supply may occur, resulting in loss of cooling. Food quality and flavor may be affected. If nuisance tripping has occurred, and if the condition of the food appears poor, dispose of it.

NOTE: Before performing any type of installation, cleaning, or removing a light bulb, remove the top grille and turn the master power switch to OFF or disconnect power at the circuit breaker box.

When you are finished, turn ON the master power switch or reconnect power at the circuit breaker box. Then reset the control to the desired setting.

15

Image 15
Contents 2327570A Instructions D’INSTALLATIONTable of Contents ÍndiceTable DES Matières Your safety and the safety of others are very important Refrigerator SafetyModels Side by Side Non-Dispensing Refrigerators Design SpecificationsModels Side by Side Dispensing Refrigerators Front View Product DimensionsSide View Top View42 106 cm Models Door Swing DimensionsTipping Radius Side Tipping RadiusCustom Panel Series Handle Optional Extended Door Handle and Door Clearances for Custom Panel SeriesDoor Door Panels for Dispenser Models Custom PanelsTop Grille Panel Door Panels for Non-dispenser ModelsDoor Panel Side View Full-Overlay Custom PanelsTop Grille Panel Routing Requirements Door Panels Routing RequirementsRefrigerator and Side Trim Dimensions Stainless Steel Series Side PanelsRefrigerator Custom Panel Series Side Panels Refrigerator Inset Installation DimensionsFlush Installation Dimensions Recessed Inset Installation DimensionsInstallation Requirements Tools and PartsLocation Requirements Electrical Requirements Recommended Grounding MethodModel Width a as shown above Water Pressure Installation InstructionsWater Supply Requirements Unpack the RefrigeratorReduce Tipping Radius Move the Refrigerator Into HouseModel Reduced Tipping Radius Connect the Water Supply Install Anti-Tip BoardsTo Install Anti-tip Boards Style 2 Copper Line Connection Connecting to Water LineConnecting to Refrigerator Plug in RefrigeratorMove Refrigerator to Final Location Install Custom Panels Lower Leveling LegsDoor Panels Adjust Doors Door Height AdjustmentLevel Refrigerator Install Side Panel Install Base GrilleDoor Swing Adjustment Complete Installation Water System PreparationStyle 1 Non-Dispenser Models Style 2 Dispenser Models Su seguridad y la seguridad de los demás es muy importante Seguridad DEL RefrigeradorModelos Refrigeradores de dos puertas sin despachador Especificaciones DE DiseñoModelos Refrigeradores de dos puertas con despachador Vista frontal Medidas del productoVista lateral Vista superiorModelos de 42 106 cm Arco de vuelcoMedidas de oscilación de Las puertas Arco de vuelco lateralDimensiones de la agarradera Tamaño real Medida Paneles de puerta para modelos con despachador Paneles a la medidaPanel de la rejilla superior Paneles de puerta para modelos sin despachadorAgarradera común Vista superior Paneles a la medida totalmente RecubiertosRequisitos de contorneado de los paneles de la puerta Panel de la puerta Vista lateralPaneles de soporte Modelo 42 106 cm Paneles decorativos recubiertos Modelo 42 106 cmPaneles laterales de la serie de acero inoxidable Adornos laterales Requisitos DE InstalaciónPaneles laterales para la serie De paneles a la medida Piezas y herramientasModelo Anchura a como se muestra Requisitos de ubicaciónPiezas necesarias Medidas de la aberturaPresión del agua Requisitos eléctricos Requisitos del suministroDe agua Método de conexión a tierra recomendadoModelo Arco de vuelco reducido Instrucciones DE InstalaciónCómo desempacar su Refrigerador Cómo reducir el arco de vuelcoCómo hacer entrar el refrigerador en la casa Cómo instalar los tableros AntivuelcoCómo instalar los tableros antivuelco Estilo 1 Conexión de la válvula de cierre Conexión del suministro de aguaConexión al refrigerador Cómo mover el refrigerador a su Ubicación finalCómo enchufar el refrigerador Baje las patas niveladorasPaneles de la puerta Cómo instalar los paneles a la medidaCómo nivelar el refrigerador Cómo ajustar las puertasCómo ajustar la altura de la puerta Cómo instalar el panel lateral Cómo instalar la rejilla de La baseCómo ajustar la oscilación de las puertas Cómo terminar la instalación Preparación del sistema De aguaVotre sécurité et celle des autres est très importante Sécurité DU RéfrigérateurModèles Réfrigérateurs côte à côte sans distributeur Spécifications DE DesignModèles Réfrigérateurs côte à côte avec distributeur Vue avant Dimensions du produitVue latérale Vue de dessusModèles de 42 106 cm Dimensions pour le pivotement Des portesRayon de basculement Rayon de basculement latéralDimensions de la poignée Taille réelle Panneau 3,2 cm Exigences dusinage du panneau de la grille supérieure Panneau de la grille supérieurePanneaux de porte pour modèles sans distributeur Panneaux de porte pour modèles avec distributeurPanneau de porte Vue latérale Panneaux de revêtement PersonnalisésExigences dusinage des panneaux de porte Poignée standard Vue supérieurePanneaux de soutien Modèle 42 106 cm Dimensions du réfrigérateur et des garnitures latéralesRéfrigérateur Panneaux de revêtement Modèle 42 106 cmPanneaux latéraux de la série de panneaux personnalisés Dimensions pour un panneau inséréDimensions pour un panneau en affleurement Dimensions pour un panneau inséré en retraitOutillage requis Exigences D’INSTALLATIONOutillage et pièces Pièces nécessairesExigences d’emplacement Dimensions de l’ouvertureModèle Largeur a tel quillustré ci-dessus Méthode recommandée de mise à la terre Pression de leau Instructions D’INSTALLATIONDéballage du réfrigérateur Réduction du rayon de BasculementFaire entrer le réfrigérateur dans Le domicile Installation de planches AntibasculementInstallation des planches antibasculement Raccordement à la canalisation DeauStyle 1 Raccordement sur robinet darrêt Déplacement du réfrigérateur à Lemplacement final Brancher le réfrigérateurRaccordement au réfrigérateur Installation des panneaux Personnalisés Déploiement des pieds de NivellementPanneaux de porte Nivellement du réfrigérateur Ajustement des portesAjustement de la hauteur des portes Installation du panneau latéral Installation de la grille De la baseAjustement de l’ouverture des portes Préparation du système d’eau Achever l’installationAll rights reserved 2327570A

2327570A, KBUDT4255E, KBUDT4855E, KBUDT4265E, KBUDT4875E specifications

Thermador is a name synonymous with luxury and innovation in the kitchen appliance industry. Among its premier offerings are a range of under-counter wine preservation and refrigeration units like the KBUIT4275E, KBUIT4855E, KBUDT4275E, KBUIT4255E, and others that promise to elevate both functionality and aesthetics in your home.

The KBUIT4275E and KBUIT4855E are designed with seamless integration in mind, offering a sleek, modern look that fits effortlessly into any kitchen decor. These units have adjustable shelving, allowing for customized storage options for various bottle sizes, accommodating everything from standard wine bottles to larger formats.

Featuring advanced cooling technologies, the Thermador wine units maintain optimal temperature and humidity levels, essential for preserving wine quality. With dual temperature zones available in models like the KBUIT4855E, wine enthusiasts can store both red and white wines at their ideal serving temperatures simultaneously.

One of the standout features across the KBUIT and KBUDT lines is the use of innovative whispering quiet technology, reducing noise levels to ensure that your wine storage remains a serene part of your culinary space. Additionally, their UV-blocking glass doors protect your wine from harmful light exposure, preserving its integrity for longer periods.

For those who prioritize convenience, models like the KBUDT4255E come equipped with a soft-close feature, ensuring the doors gently close without slamming, which not only adds to the longevity of the unit but also enhances the user experience.

Thermador also integrates Smart Home technology in some models, allowing users to control temperature settings through their smartphones. This kind of technological advancement appeals to tech-savvy homeowners seeking seamless connectivity in their kitchen.

The aesthetic design is equally compelling, with options for panel-ready finishes that enable these wine units to blend seamlessly with existing cabinetry, offering a custom look.

In conclusion, Thermador’s under-counter wine preservation and refrigeration units are not just appliances; they are a fusion of state-of-the-art technology, user-friendly features, and elegant design. Whether choosing the KBUIT4265E or the KBUDT4875E, wine lovers can appreciate the careful craftsmanship and attention to detail that goes into every model, ensuring an exquisite experience with wine storage and preservation.