BEFORE INSTALLING HOOD
closed.
Wall Mount Installation - HS and HSB series only. (see Figure 5)
1.After the hood installation height has been determined draw a horizontal line at a distance above the cooktop equal to the desired hood installation height plus 7- 1/2”.
2.Find the centerline of the cooktop. Draw a vertical line along this centerline up to the horizontal line drawn in step 1 and draw a vertica line right and left at a distance of 12 - 5/8” to determine the mounting location of the mounting hooks shipped with the hood.
3.Fit two mounting hooks on the wall to hang the hood through the provided slots (2 wall anchors+2 hooks + 2 screws 5x45).
4.Run 8” Duct, long enough to reach the transition once the hood has been installed plus 1 1/2” inch to connect ductwork.
Fix Duct to transition with screws and seal with tape.
5.If mounted, remove the grease filter.
6.Remove 1 of 2 knockouts and install 1/2” conduit connector in
7.Hang the hood and adjust its position through the screws on the hooks.
8.Fix the hood to 4 additional point,2 on upper side, 2 on lower side (use 4 wall anchors + 4 washers + 4 screws 5x35.
HOOD WIDTH | DIM. "W" DIM. "K" | DIM. "Z" | |
30" | 29 - 1/8" | 2 - 1/2" 7 - 1/16" | |
36" | 35 - 1/16" | 2 - 1/2" 7 - 1/16" | |
42" | 41 - 1/16" | 2 - 1/2" 7 - 1/16" | |
48" | 47 - 1/16" | 2 - 1/2" | 7 - 1/16" |
Table 3 |
|
|
|
Transition |
| Side slot | |
|
| for cabinet | |
|
| bottom mount. | |
|
|
| Top |
|
|
| screw |
|
|
| location |
Top |
| Z | K |
outlet | W |
| |
Knockouts |
|
| |
|
|
| |
(junction box) |
|
|
|
Top |
|
| Square |
screw |
|
| slot |
location
7 1/2" | bottom mounting | |
screws locations | ||
|
W
CL | Z |
| |
| K |
| Hook for wall |
| Screw for |
| installation |
| cabinet |
| 25 3/16" | bottom | |
|
|
| installation |
7 1/2" | 12 5/8" | 12 5/8" | Adjusting |
|
| screw | |
| CL | ||
| Bottom of the Hood | ||
|
|
| |
Figure 5
Page 11