Wall Mount Installation

Note: see below if cabinet installation is preferred

3.After the hood installation height has been determined draw a horizontal line at a distance above the cooktop equal to the desired hood installation height plus 7- 1/2”. See also Figure 4a.

4.Find the centerline of the cooktop. Draw a vertical line along this centerline up to the hori- zontal line drawn in step 1 and draw a vertical line right and left at a distance of12-5/8” to determine the mounting locationof the mounting hooks shipped with the hood.

5.Fit two mounting hooks on the wall to hang the hood through the provided slots (2 wall anchors + 2 hooks + 2 screws 5x35).

6.Run 10” Duct, long enough to reach the transition once the hood has been installed plus 1 1/2” inch to connect ductwork. Fix Duct to transition with screws and seal withtape.

7.Remove 1 of 2 knockouts and install 1/2” conduit connector in j-box.

8.Hang the hood and adjust its position through the screws on the hooks.

9.Fix the hood to 4 additional point, 2 on upperside, 2 on lower side (use 4 wall anchors

+4washers + 4 screws 5x35.

Cabinet Installation:

Note: See above if wall mount installation is preferred

Note: Distances on Table 3.3.

Find the centerline of the cabinet bottom. Draw a line along this centerline from rear to front of the cabinet. See also Figure 4b.

4.Draw two lines, one at a K distance from thewall, the other one at a Z distance from theprevious line. Mark 4 points, two along each line at a distance of half W from the center line, to determine the screw locations.

5.Fit 4 screws on cabinet bottom do not tighten completely but leave a space of about 1/2” from cabinet bottom surface and head screws.

6.Run 10” Duct, long enough to reach the transition once the hood has been installed plus1 1/2” inch for connect ductwork.

7.Remove 1 of 2 knockouts and install 1/2”conduit connector in j-box.

8.Hang the hood on screws through side slots provided on hood top.Tighten the four screws. Note: If possible fix the hood on the wall at 4 additional point (2 on upper side, 2 on lowerside).

9.From the inside of the cabinet attach the transition on upper outlet.

HOO D W IDTH	DIM. "W "	DIM. "K "		DIM. "Z"
30"	29 - 1/8"	2	- 1/2"	7	- 1/16"
36"	35 - 1/16"	2	- 1/2"	7	- 1/16"

Table 3

Figure 4a	Side slot x 4
	Center Hole

Figure 4b