Philips MCi900/12 user manual Wired connection, Press / repeatedly to select the entry location

E n g l i s h

12V=1A To Mode m LAN4 LAN3 LAN2 LAN1 Reset

•Press / repeatedly to select the entry location;

•To enter the desired digits, use the alphanumeric buttons on the remote control; or press / repeatedly.

Note

•• Ensure that you never enter an IP address that is already assigned to a computer/device on the network.

Wired connection

MCi900

Connect to the router by using the Ethernet cable

1 Select [Yes], when asked whether to set up network connection (see ‘First-time setup’ on page 28).

2 Use an Ethernet cable to connect the unit to the router.

Connect to the home Wi-Fi/wired network

•On the unit, select [Wired (Ethernet)]. »» The unit starts to acquire an IP address

assigned by the network automatically.

»» A message appears when the connection is completed successfully.

2/2

Wireless (WiFi)

Wired (Ethernet)

Tip

•• The router may fail to assign an IP address, if the DHCP (Dynamic Host Configuration Protocol) is unavailable or disabled on the router. You may need to enter the IP address manually, or press BACK to start re- connecting.

EN 33