Cleveland Range 21CET16, 24CEA10, 21CET8 manual Introduction, Operational Safety

Page 5

SECTION 1: INTRODUCTION

To use a SteamCraft Convection Steamer safely and effectively, each operator must read and understand this Manual completely before starting operation. The owners and operators of the steamer should retain this Manual in an easily accessible location for future reference and training.

The owner(s) and operator(s) of the steamer must be aware that steam can cause serious injuries and equipment damage. Pay particular attention to the Operational Safety section of this chapter, and the WARNINGS and CAUTIONS displayed in this manual and on the equipment.

WARNING

DO NOT ATTEMPT TO START OR OPERATE a SteamCraft steamer during a power outage.

DEATH, INJURY, AND EQUIPMENT DAMAGE could result from the improper installation of a steamer.

Before starting a recently installed or repaired steamer, be sure it has been installed by qualified personnel according to the instructions found in the separate Installation and Maintenance Manual.

A. OPERATIONAL SAFETY

The safe and effective operation of any steamer depends upon proper installation, use, maintenance, and repair. Operational safety must encompass all of these factors. This Operational Safety section outlines the minimum safety policies that should be considered when using one or more SteamCraft steamers. It is assumed that any operational safety program must be tailored to the specific site and use of the equipment.

Burn hazards are present in any professional food service operation. When using the steamer, observe the following precautions.

•Remember at all times that steam can cause severe burns.

•When checking inside the steamer always open the door slowly and stand to the side and back away from the steamer. Water leaking from the door gasket can be a sign of a blocked drain. If the drain is blocked, hot water can accumulate inside the compartment and spill out when the door is opened.

•Make sure the compartment is turned OFF. Open the door slightly to allow steam to vent before looking or reaching into cooking compartment.

•Do not reach into the cooking compartment until the steam has cleared.

•Do not reach into steamer or handle hot items without wearing heatproof gloves. Wet or damp gloves conduct heat, and may cause burns when touching hot items.

•Do not use anything but your hands to operate the ON/OFF controls.

•Do not block the vents on the side, rear or underside of the unit or otherwise obstruct the flow of ventilation air to the steamer. Do not store articles on top of the unit.

The steamer requires a minimum of service if properly operated and maintained by trained personnel. The following steps will help keep the steamer in a safe, efficient operating condition.

(1)Do not store or leave combustible materials near the steamer. Keep the area around and under the steamer free of combustible materials.

(2)Non slip draining mats should be on the floor in front of the steamer to prevent slipping accidents from spilled water.

1

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Part No. CET-OPM Rev a 1/01 Operators ManualFor the User OPERATOR’S Manual Chapter Table of ContentsSection Steam Cooking Guidelines Table of ContentsLimited Warranty Introduction Operational SafetySerial Number Product InformationModel Number Product Information PlateModel 21CET8 Pictured Product DescriptionCompartment Control Panels Dial Timer Control PanelCooking Operations Keypad Control Panel Keypad Timer Control PanelTimer Operation TIMED/MANUAL Switch SteamCraft Ultra 3 Timer DisplayNumber Pad Keys START/STOP KeyGeneral Operation Power on Automatic FillPreheating the Steamer Descaling Required Light FeatureInspecting the Cooking Compartment Cooking with the Steamer Manual Cooking Procedure Operating and Cooking Procedure Manual ModeUsing the Timer in Manual Mode Power Off Automatic Blowdown Shutdown and Cleaning ProceduresSteam Generator Blowdown Blowdown FrequencyShut Down and Cleaning Blowdown ProcedureInner Door Assembly Maintenance Preventative Maintenance TroubleshootingWeekly/Monthly Maintenance Descale Steam Generator Atmospheric Steam Generator Descaling Procedure For Dissolve Descaler Solution Part NoProblem Possible Cause REMEDY/REFERENCE Operators Troubleshooting GuideTrouble Shooting Guide OFF See Warning underProper operation, see To verify the steamersDescale unit, it is just a Reminder that steamerTroubleshooting Notes Introduction Steam Cooking GuidelinesSizing UP PAN Capacity Reference Charts for Typical Pan CapacitiesServing Sizes How Much? How Many? Serving SizeFruits From previous Steaming Tips Lobster Crab Shrimp Limited Extended Warrnty Coverage Limited Warranty
Related manuals
Manual 6 pages 10.59 Kb

21CET16, 21CET8, 24CEA10 specifications

Cleveland Range has built a reputation for innovation and quality in the foodservice industry, particularly known for its combination ovens, braising pans, and steamers. Among their impressive lineup are models 24CEA10, 21CET8, 21CET16, 21CGA5, and 24CGA10, each designed to enhance kitchen efficiency and ease of use while preparing a wide variety of dishes.

The 24CEA10 is an advanced combi oven which excels in producing consistent, high-quality results. This model features advanced convection technology, allowing for even heat distribution throughout the cooking chamber. It also comes equipped with programmable cooking modes, optimizing the cooking process for various foods, from baked goods to large cuts of meat. The unit's user-friendly interface simplifies navigation through different settings, while the built-in monitoring systems provide real-time feedback on cooking progress.

Next is the 21CET8, a compact and versatile electric steam generator ideal for smaller kitchens. This model stands out for its energy efficiency and low water consumption, which not only reduces operational costs but also supports sustainability initiatives. The 21CET8 utilizes a sophisticated control system that allows chefs to precisely adjust temperature and steam settings, ensuring optimal cooking conditions for everything from delicate vegetables to robust seafood dishes.

The 21CET16 offers larger capacity while maintaining the same level of efficiency as its smaller counterpart. This model is designed for high-volume cooking operations and ensures that chefs can prepare large batches of food without sacrificing quality. It features dual steam generation capabilities, allowing for rapid heating and cooking, which is crucial during peak hours.

A new addition to the lineup is the 21CGA5, a gas model that emphasizes performance and durability. With its stainless steel construction, this unit is built to withstand the rigors of a busy kitchen. The 21CGA5 incorporates precise temperature controls and rapid heat recovery, making it ideal for restaurants and catering operations that demand consistent results under pressure.

Finally, the 24CGA10 combines the benefits of gas cooking with advanced technology. This model features a high-efficiency burner system and robust insulation, which work together to provide faster cooking times and reduced energy consumption. The 24CGA10 also includes a self-cleaning feature, enhancing maintenance ease and allowing operators to focus on food preparation rather than equipment upkeep.

In summary, the Cleveland Range models 24CEA10, 21CET8, 21CET16, 21CGA5, and 24CGA10 represent a powerful collection of cooking equipment designed to improve efficiency, support various cooking methods, and deliver exceptional results, proving invaluable in any foodservice operation.
Top Page Image Contents