PROBLEMS WITH YOUR BEVERAGE COOLER?
You can solve many common Beverage Cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer.
TROUBLESHOOTING GUIDE
PROBLEM | POSSIBLE CAUSE |
Beverage Cooler does not operate. | Not plugged in. |
| The appliance is turned off. |
| The circuit breaker tripped or a blown fuse. |
Beverage Cooler is not cold enough. | Check the temperature control setting. |
| The door is opened too often. |
| The door is not closed completely. |
| The door gasket does not seal properly. |
Turns on and off frequently. | The room temperature is hotter than normal. |
| A large amount of contents has been added to |
| the Beverage Cooler. |
| The door is opened too often. |
| The door is not closed completely. |
| The temperature control is not set correctly. |
| The door gasket does not seal properly. |
The light does not work. | Not plugged in. |
| The circuit breaker tripped or a blown fuse. |
| The light button is “OFF”. |
Vibrations. | Check to assure that the Beverage Cooler is |
| level. |
The Beverage Cooler seems to make too much | The rattling noise may come from the flow of the |
noise. | refrigerant, which is normal. |
| As each cycle ends, you may hear gurgling |
| sounds caused by the flow of refrigerant in your |
| Beverage Cooler. |
| Contraction and expansion of the inside walls |
| may cause popping and crackling noises. |
| The Beverage Cooler is not level. |
The door will not close properly. | The door is misaligned. |
| The Beverage Cooler is not level. |
| The gasket is dirty. |
| The shelves are out of position. |
Display flashes Error message “E0” | Connection failure – there is a wire or component |
| that is not connected correctly. |
| Contact the Avanti Service Department – |
| 1 – 800 – 220 – 5570 |
Display flashes Error message “E1” | Temperature sensor failure. |
| Contact the Avanti Service Department – |
| 1 - 800 – 220 - 5570 |
|
|
Display flashes Error message “E2” | Defrost sensor (Coil Sensor) failure. |
| Contact the Avanti Service Department – |
| 1 - 800 – 220 – 5570 |
|
|
Display flashes Error message “HH” | Temperature of inner cabinet is over 99ºF / 37ºC |
Display flashes Error message “LL” | Temperature of inner cabinet is under 32ºF / 0ºC |
| |
|
|
13