Sennheiser EK 500 G2 manual Preparing the receiver for use, Inserting and replacing the batteries

Page 11

Preparing the receiver for use

Inserting and replacing the batteries

For powering the receiver, two 1.5 V AA size batteries are required.

Press the two unlocking buttons

and open the

battery compartment cover .

 

Insert the two batteries as shown above. Please observe correct polarity when inserting the batteries.

Close the battery compartment. The battery compartment cover locks into place with an audible click.

Inserting and charging the accupack

The receiver can also be powered via the rechargeable Sennheiser BA2015 accupack. Insert the accupack into the battery compartment as described above.

The receiver has two charging contacts and a sensing contact on its short sides. The accupack can be recharged while remaining in the receiver. Insert the receiver into the L 2015 charger (see operating manual of the L 2015 charger).

Note:

For accupack operation of the receiver, only use the BA 2015 accupack in order to ensure optimum operational reliability. For charging the accupack, only use the L 2015 charger. Both the accupack and the charger are available as accessories.

The accupack is fittedwithan integratedsensorwhich is

via a third contact – monitored by the electronics of the receiver andthe charger. The sensoris necessary for the following control purposes:

y The taking into account of the different voltage cha- racteristics of primary cells (batteries) andaccupacks. The battery status indications onthe displays andthe switch-offthresholds at the end of the operatingtime

11

Image 11
Contents Instructions for use Thank you for choosing Sennheiser Contents Channel bank system EK 500 G2 receiverSafety instructions Delivery includes Areas of applicationOperating controls Indications and displays of the receiver Operation and battery status indicationIndications and displays LC display panelDisplay backlighting RF signal indicationPilot display Modulation display Remote displays of an ew 500 G2 transmitterMute display Inserting and charging the accupack Preparing the receiver for useInserting and replacing the batteries Mounting the receiver to a camera Connecting units to the audio outputAttaching the receiver to clothing Connecting the headphones Using the receiverSwitching the receiver on/off Volume up? no Activating/deactivating the lock modeButtons Operating menuSelecting a menu Overview of menusWorking with the operating menu Getting into the operating menuExiting the operating menu Adjusting a settingStoring a setting Operating menu of the receiver ExitFreq Name Switching between the channels ina channel bank Chan Adjustment tips for the operating menuSwitching between channel banks Bank Releasing locked channels Scanning the channel banks for free channels ScanMulti-channel operation Starting the scan and storing the scan resultImportant notes Adjusting the audio output level- AF OUTAdjusting the squelch threshold- Sqelch Entering a name Name Loading the factory-preset default settings ResetSelecting the standard display Dislpy Exiting the operating menu Exit Activating/deactivating the lock mode LockActivating/deactivating the pilot tone evaluation- Pilot Error checklist TroubleshootingFor multi-channel operation Care and maintenanceRecommendations and tips For optimum receptionHDX noise reduction Wireless transmission systemsAdditional information Field strength-dependent squelch SquelchPilot tone squelch Specifications 2015 AccessoriesConnector assignment Batteries or rechargeable batteries Warranty regulationsManufacturer declarations CE Declaration of Conformity