Sennheiser EK 500 G2 manual Care and maintenance, Recommendations and tips, For optimum reception

Page 27

Recommendations and tips

... for optimum reception

yTransmissionrange depends to a large extent on location and can vary from about 10 m to about 150 m. There should be a “free line of sight” between transmittingand receivingantennas.

yTo avoid overmodulating the receiver, observe a minimum distance of 5 m between transmitting and

receivingantennas.

... for multi-channel operation

y For multi-channel operation, you can only use the channels ina channelbank. Eachof the channelbanks “1” to “8” accommodates up to 20 factory-preset frequencies which are intermodulation-free. For alternative frequency combinations, please refer to the enclosed frequency table. The freely selectable frequencies can be selected via the “TUNE” menu and can be stored in the channel bank “U”.

y When using several transmitters simultaneously, interference can be avoided by maintaining a minimum distance of 20 cm between two transmitters.

Care and maintenance

Use a slightly dampclothto clean the receiver from time to time.

Note:

Do not use any cleansing agents orsolvents.

27

Image 27
Contents Instructions for use Thank you for choosing Sennheiser Contents Channel bank system EK 500 G2 receiverSafety instructions Delivery includes Areas of applicationOperating controls Indications and displays of the receiver Operation and battery status indicationIndications and displays LC display panelRF signal indication Pilot displayDisplay backlighting Remote displays of an ew 500 G2 transmitter Mute displayModulation display Preparing the receiver for use Inserting and replacing the batteriesInserting and charging the accupack Mounting the receiver to a camera Connecting units to the audio outputAttaching the receiver to clothing Using the receiver Switching the receiver on/offConnecting the headphones Volume up? no Activating/deactivating the lock modeButtons Operating menuSelecting a menu Overview of menusWorking with the operating menu Getting into the operating menuAdjusting a setting Storing a settingExiting the operating menu Operating menu of the receiver ExitFreq Name Adjustment tips for the operating menu Switching between channel banks BankSwitching between the channels ina channel bank Chan Releasing locked channels Scanning the channel banks for free channels ScanMulti-channel operation Starting the scan and storing the scan resultAdjusting the audio output level- AF OUT Adjusting the squelch threshold- SqelchImportant notes Loading the factory-preset default settings Reset Selecting the standard display DislpyEntering a name Name Activating/deactivating the lock mode Lock Activating/deactivating the pilot tone evaluation- PilotExiting the operating menu Exit Error checklist TroubleshootingFor multi-channel operation Care and maintenanceRecommendations and tips For optimum receptionWireless transmission systems Additional informationHDX noise reduction Squelch Pilot tone squelchField strength-dependent squelch Specifications Accessories Connector assignment2015 Batteries or rechargeable batteries Warranty regulationsManufacturer declarations CE Declaration of Conformity