STEP 4: Prepare The Wall & Upper Cabinet
W A R N I N G
To avoid risk of personal injury, electrical shock or death:
Note where electrical outlets and electrical wires are before you drill into the wall. 
Locate and disconnect power to any electrical circuits that could be affected by installing this oven.
W A R N I N G
To avoid risk of personal injury, electrical shock or death, cover the edge of the power supply cord hole with the power supply cord bushing.
Drill The Holes In The Wall And Upper Cabinet.
1.Drill holes on the circles. If there is a stud, drill a 3/16" hole for lag screws. If there is no stud, drill a 3/4" hole for toggle bolts. Make sure to use at least 2 lag screws in a stud, and 4 toggle screws in the drywall or the plaster.
2.Drill a 3/8” hole at points J and K on the upper cabinet template.
NOTE: If the bottom of the upper cabinet is recessed 3/4" or more, you will need 2"x 2" filler blocks (not included) to provide additional support for the bolts. See Figure 25.
Mark the center of each filler block and drill a 3/8” diameter hole at the marks.
Align filler blocks over the two openings in the top of the microwave oven cabinet and attach to cabinet with masking tape. See Figure 26.
3.Cut or drill a 2" diameter hole at the area marked M. Power supply cord hole on the upper cabinet template. If the upper cabinet is metal, you will need to cover the edge of the hole with the power supply cord bushing (supplied) to prevent damage to the cord from the rough metal edge.
4.Cut out the venting areas (with the saber saw):
REAR WALL TEMPLATE.
5.Complete whichever venting system you have chosen. Use caulking compound to seal the exterior wall or roof opening around the wall cap or roof cap.
Cabinet Front | Filler Block Cabinet |
| Bottom Shelf |
Figure 25
Filler
Block
Figure 26
– 14 –