LG Electronics LMV1630WW Prepare The Venting System, Wall Venting, Roof Venting, Room Venting

STEP 2: Prepare The Venting System

NOTE: The ductwork you need for outside ventilation is not included with your oven. The standard ductwork fittings and length are shown in Figure 10, page 9.

W A R N I N G

THIS OVEN MUST BE PROPERLY VENTED!

You may vent your oven in one of three ways. However, do NOT vent into a wall cavity, an attic, or an unused area.

Roof-ventingIf your oven is located on an outside wall near the roof, as in Figures 7 (3 1/4" x 10" duct) and Figure 9 (6" round duct.)

Wall-ventingIf your oven is located on an outside wall of your house, as in Figure 6 (3 1/4" x 10" duct) and Figure 9 (6" round duct.)

Room-ventingIf your oven is located on an inside wall of your house, as in Figure 8.

NOTE: If you choose the rear exhaust method (roof or wall-venting), be sure there is enough clearance within the wall for the exhaust duct.

	Wall Venting
Cabinet
		Wall Cap
Oven		3 1/4"x10" Through-the-wall Duct
Wall Mounting		Duct

Figure 6

Roof Venting

Roof Cap

Cabinet

3 1/4"x10"

Duct

Oven

Through-the-roof

Roof Venting

Figure 7

REMEMBER AS YOU INSTALL THE VENTING:

Keep the length of the ductwork and the number of elbows to a minimum to ventilate your oven efficiently. See examples on page 9.

Keep the size of the ductwork the same.

Do not install two elbows together.

Use duct tape to seal all joints in the duct system.

Room Venting

Cabinet

Oven

Roof Cap

6"min diameter		Wall Cap
Round Duct
Elbow
3 1/4" to Round
Duct Transition
		3 1/4" to Round
	Ductwork Transition

Use caulking to seal the exterior wall or roof opening around the cap.

Figure 8 Figure 9

– 8 –