INSTALLATION INSTRUCTIONS
ELECTRICAL CONNECTIONS (cont.)
IF COOKTOP IS USED IN A NEW BRANCH CIRCUIT INSTALLATION (1996 NEC), MOBILE HOME, RECREATIONAL VEHICLE, OR WHERE LOCAL CODES DO NOT PERMIT GROUNDING TO THE NEUTRAL (WHITE) WIRE
Observe all governing codes and local ordinances.
Disconnect the power supply.
At the circuit breaker box, fuse box or junction box, connect appliance and power supply cable wires as shown.
WARNING: If connecting to a
4-WIRE GROUNDED JUNCTION BOX
Cable from power supply
White wire
Ground(no connection) wire
Red
wires Black wires
| Junction box | |
Green wire(ground) | ||
connector | ||
| ||
Cable from cooktop |
|
COOKTOP INSTALLATION
Visually inspect the cooktop for damage. Make sure all cooktop screws are tight (see below for locations).
Screws |
Carefully lower the cooktop into the
WARNING: Do not remove the nylon spacers on the edges of the cooktop. These spacers center the cooktop in the space provided. The cooktop must be centered to allow proper venting and to prevent excess heat buildup that may result in heat damage or fire.
Nylon spacers
LGE Internal Use Only | - 15 - | Copyright © 2007 LG Electronics. Inc. All right reserved. |
|
| Only for training and service purposes |