HOW TO DISASSEMBLE AND ASSEMBLE
6. DISPENSER
1)Disconnect funnel and button assembly by pulling down and forward.
Button
4) Loosen four screws with a phillips screwdriver and pull | |
FunnelAssembly | Funnel |
the fu nel a | to disconnect. |
Assembly
2)Remove display frame assembly by making a gap between a display frame assembly and door with a flat blade screwdriver and pulling it forward. The cover dispenser is attached with a hook.
5) The duct cap assembly canHoldeberdiscoSolenoidnected if the hold lever connecting screw is osened with a phillips driver.
LeverAssembly AssemblyDuctCap
3)The display assembly can be connected by pressing the top of the dispenser cover and pushing it after separating the display frame from its housing.
6) To install the duct cap ass | mbly, ins | rt one end of the | ||
spring into the right hole of the dispenser lever and | ||||
insert the other end into | right hole in the top part of | |||
the dispenser. Then attach the hold | at the solenoid | |||
switch. | Sheath HeaterSpring | |||
SolenoidAssembly | ||||
|
| DispenserLever |
- 87 -