When reassembling the Wok burner, turn over the large base ring and find the ‘D’ shaped area.
Turn the head until the ‘D’ matches the one on the burner base. Turn the head over and place it on the burner base. To fit the small inner burner, find the larger electrode notch in the burner rim. Line this up with the white ignition electrode and place the inner burner on the large base ring.
cloth. The oven doors should only be cleaned with a soft cloth wrung out in clean hot soapy water.
Cookers with window doors
On some models the oven door front panel can be taken off so that the glass panels can be cleaned. If the top edge of the oven door of your cooker has a line of holes and there are screws in the side edges then it can be taken apart for cleaning.
Move the cooker forward to gain access to the sides (see the ‘Moving the cooker’ section of these instructions).
Open the oven door slightly and remove the front panel fixing screws from the door sides (two each side).
Now fit the two trim rings, making sure that they are sitting down properly.
Grill
The face of the grill burner will darken with use - this is perfectly normal. Any fat or grease will burn off. Do not try to clean it - the small holes could get blocked and affect burner performance.
The grill pan and grid should be washed in hot soapy water. Stubborn particles may be removed from the grid by using a nylon brush.
Control Panel and Doors
Avoid using any abrasive cleaners including cream cleaners, e.g. Cif, on brushed Stainless Steel surfaces. For best results use a liquid detergent e.g. Domestos Multi Surface Cleaner.
The control panel and control knobs should only be cleaned with a soft cloth wrung out in clean hot soapy water - but take care that no surplus water seeps into the appliance. Wipe with a clean dampened cloth then polish with a dry
some window doors only
Carefully lift off the outer door panel. The inside face of the glass panels can now be cleaned - take care not to disturb or wet the door insulation. Please note that the door is triple glazed but the inner two panels are fixed and should not be separated. After cleaning carefully refit the outer door panel and replace the side fixing screws.
The Main Oven
Cleaning is easier if carried out while the oven is still warm. Before cleaning, cover the burner to prevent the burner holes becoming blocked.
The inside of the oven and inner door panel can be cleaned using any cleaner bearing the Vitreous Enamel Association (VEA) label.
Take care not to disturb the oven thermostat temperature sensor at the top of the oven opening.
15