John Lewis JLRC101 Electrical Connection, Permanent connection, Electric power cable section

Electrical Connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING: THIS APPLIANCE MUST BE EARTHED. Should the appliance power supply cable need to be replaced, this must be carried out by a Service Force agent (see page 27). The manufacturer declines any liability should this safety measure not be observed.

To replace the electric cable, it is necessary to access the terminal board. It is located on the back of the appliance, at the top left, (see diagram below).

Proceed as follows:

•Open the terminal board box;

•Unscrew the screw A that locks the cable;

•Loosen the screw contacts and replace the cable with one of the same length that corresponds to the specifications in the table in section "Electric power cable section";

•The "yellow-green" earth wire must be connected to the

terminal and must be approximately 20 mm longer than the line cables;

•The neutral "blue" wire must be connected to the terminal marked with the letter N;

•The line wire “brown” must be connected to the terminal marked with the letter L.



. 





0

Permanent connection

For permanent connection it is necessary to

install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

Electric power cable section

According to the type of power supply, use a cable that conforms to the following table.

Running at 230V1N~: use a tripolar cable type H05RR-F (cable measuring 3 x 2.5 mm2).

91a PP 

PP

The end to be connected to the appliance must have the earth wire (yellow-green) at least 20 mm longer.

#

8