Trim OUT

Now that cases have been positioned and leveled, you may proceed to trim-out case line- up. Trim parts have been designed to be applied easily with only a small number of fas- teners required. Most external parts are adjustable to achieve almost invisible, snug-fit- ting joints and a high level of excellence in fit and finish.

BUMPER

JOINT

BUMPER

SCREW

Adjust polymer1master bumper joints, if required. First loosen bumper screws.

Slide bumper2joint to the center of the joint between the two cases. Use screw driver in hole provided.

Slide master3bumper left or right to close seam as required. Bumper joint neatly finishes any gap that may remain.

Close seam where4bumper joins case end. Bumper joint closes seam that may develop if master bumper is moved away from end to close case- to-case joint seam.

Seal joints along5pipe chase seam with the caulk provided.

ACRYLIC

TAPE

PIPE

CHASE

Apply acrylic tape6over pipe chase seam. Tape is found with the ship loose items and acts as a watershed preventing water from settling in case joint.