Multiquip WM-70P (Plastic) WM-70 PLASTER/MORTAR Mixer Electric Motor, Electric Motor Connection

WM-70 PLASTER/MORTAR MIXER — ELECTRIC MOTOR

Electric Motor

For maintenance care and operation of the electric motor, refer to your electric motor instruction booklet furnished with the motor.

Protect the electric motor from dust as much as possible and keep ventilating openings clean.

CAUTION	Electric Motor
	Safety

DO NOT spray water at any time on the electric motor.

DO NOT operate electric motor in a explosive environment.

The electric motor used in this mixer is a single-phase 1.5 HP motor. The input voltage requirement for this motor is either 115 or 230 VAC only.

Electric Motor Connection

A12-inch electrical cable (Figure 7) is provided with the electrical motor for hookup to a power source.Table 5 shows the required NEMA connector for the desired motor horsepower rating. In addition, Table 5 also shows the matching NEMA approved connector for the required extension cord.

CAUTION	Electric Motor
	Connections

ALWAYS make certain that the power source required for the electric motor is correct and always use the correct NEMA configuration plug. Failure to supply the correct voltage to the motor can severely damage the motor.

TABLE 5. ELECTRIC MOTOR WIRING INFORMATION

Motor	115-230 VAC - Single Phase
Horsepower	NEMA Plug Connector	Mating NEMA
Rating
		Receptacle Connector
1.5 HP	L5-20P P/N EM940537	L5-20R P/N EM940538
(115 VAC)
1.5 HP	L6-20P P/N 940539	L6-20R P/N 940540
(230 VAC)

NOTE It is strongly recommended that all electrical wiring be done by a

licensed electrician.Figure 7. Single Phase Electric Motor With 12-inch Pigtail

Special attention should be given to the electric switch as well as the over-and-under voltage protection devices as per regulations set forth in the local electrical safety code handbook

PAGE 18 — WM-70 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (08/09/04)