WM-70 PLASTER/MORTAR MIXER — OPERATION
Stopping the Mixer (Gasoline Engine) | Stopping the Mixer (Electric Motor) |
1. Place the belt slip lever in the start/stop position | 1. Place the electric motor's ON/OFF switch (Figure 7) in |
(Figure 20). | the OFF position. |
2.Push the main start/stop switch (Figure 15) inward to 2. Disconnect the electric motor's extension cord from its
stop the engine. | power source. |
3.Turn the fuel
4.Disconnect the spark plug.
5.Clean mixer as referenced in the maintance section of this manual.
3.Clean mixer as referenced in the maintance section of this manual.
NOTE | It is recommended that the mixer's | |
Start/Stop switch be used to stop | ||
| ||
| the engine after every use. |
Doing this will verify that the switch is working properly and presents no danger to the operator.
DANGER
DO NOT Disconnect the Start/Stop Switch
NEVER disable or disconnect the start/stop switch. It is provided for operator safety. Serious Injury may result if it is disabled, disconnected or improperly maintained.