WM-70 PLASTER/MORTAR MIXER — INSPECTION
Fuel Check
| DANGER | Explosive Fuel |
| Hazard | |
|
|
If your mixer has a gasoline engine, determine if the engine fuel is low. If fuel is low, remove the fuel filler cap and fill with unleaded gasoline. Motor
fuels are highly flammable and can be dangerous if mishandled.DO NOT smoke while refueling. DO NOT attempt to refuel the mixer if the engine is hot! or running.
1.Remove the gasoline cap located on top of fuel tank.
2.Visually inspect to see if fuel level is low. If fuel is low, replenish with unleaded fuel.
3.When refueling, be sure to use a strainer for filtration. DO NOT
V-belt Check
A worn or damaged
Blade Check
Check for worn or paddle blades. Make sure that all blades are adjusted properly. See blade adjustment procedure in this manual. Replace all defective or damaged blades immediately.
Controls
Start/Stop Switches
This mixer has been equipped with a start/stop switch for both the gasoline and electric motor mixers.These switches should be tested every time the engine or electric motor is started.
Grease Fittings (Dumping Mechanism)
Check the zerk grease fittings at each end of the mixing drum. These grease fittings lubricate the dumping mechanism. If the dumping handle is stiff or hard to move lubricate these fittings.