Basic Functions
English
Plug and Play (for tuner installation)
Plug and play allows you to store all available radio stations automatically.
If plug and play has not been installed
1When you turn on the system,“AUTO INSTALL- PRESS PLAY” will be displayed.
2Press 38 on the system to start installation.
➜“INSTALL” will be displayed and followed by “TUNER” and then “AUTO SEARCHING”.
➜PROG will start to flash.
➜The system will search all radio stations on the FM band, and then the MW band.
➜All available radio stations with strong signal strength will be stored automatically.
➜The system will stop searching when all available radio stations are stored or when the memory for 40 preset radio stations is full.
➜The first preset radio station will play when Plug and Play is completed.
Demonstration mode
The system has a demonstration mode that shows various features offered by the system.
Activating demonstration
●In Standby or ECO power mode, press and hold STOP 7 for more than 5 seconds to activate demo mode.
➜“DEMO ON” is displayed.
➜Demonstration will begin.
Deactivating demonstration
●Press and hold STOP 7 on the system until “DEMO OFF” is displayed.
➜ The system will switch to Standby mode.
Note:
–Even if you remove the AC power cord and reconnect it to the wall socket, the demonstration will remain off until you activate it again.
Reinstalling plug and play
1In Standby or Demonstration mode, press and hold 38 on the system until “AUTO
2Press 38 again to start installation.
➜ All previously stored radio stations will be replaced.
To exit without storing the plug and play
●Press 7 on the system.
Notes:
–When the power is turned on, the disc tray may open and close to initialise the system.
–If Plug and Play installation is not completed, it will be reinitiated the next time you power on the system.
–If there is no antenna connected,“CHECK ANTENNA” will scroll on the display.
–If
18