Philips FWD39/ 21 Preparations, Inserting batteries into the remote control, Setting the clock

Preparations

IMPORTANT!

–Make sure to complete the preparation procedures before operating the system.

Step 1: Inserting batteries into the remote control

3

1

2

1Open the battery compartment.

2Place two batteries (Type R06 or AA) in the compartment with the correct polarity as indicated by “+” and “–” symbols.

3Close the cover.

Using the remote control to operate the

system

Step 2: Setting the clock

The clock can be set in either 12-hour or 24- hour mode (“PM 00:00” or “00:00” for example).

1The clock can be set in any source mode.

➜ If you have not set the clock,“--:--” will be shown on the display.

2Press and hold CLOCK/TIMER until “SELECT CLOCK OR TIMER” is displayed.

➜Press O or P to change the display to “CLOCK”.

➜Press CLOCK/TIMER again to confirm.

3Press O or P on the system to set the hours.

4Press 1 or ¡ on the system to set the minutes.

English

1 Point the remote control directly at the remote sensor (iR) on the front panel.

2 Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TAPE1/2,TUNER).

3Then select the desired function (for example 2;, O or P).

CAUTION!

–Remove batteries if they are exhausted or will not be used for a long time.

–Do not use old and new or different types of batteries in combination.

–Batteries contain chemical substances, so they should be disposed of properly.

5Press CLOCK/TIMER to confirm your setting. The system will store the setting automatically and go back to it’s previous status.

➜The time setting becomes effective. Note:

– In AUX mode, setting clock using remote control is not possible.

To exit the setting without storing (in standby mode)

●Press 9 on the system to exit.

➜“CANCEL” will appear on the display.

●Press STANDBY ON to exit setting mode and go into ECO POWER mode.

●You can also press DISC, DISC1~3, DISC CHANGE, OPEN/CLOSE to exit setting mode and go into disc mode.

●The system will also exit setting mode and go to TUNER,TAPE or AUX mode when you press the corresponding source button.

Viewing the clock in any source mode

●When you have set the clock, press CLOCK/ TIMER to view clock. Press DISPLAY on the system to toggle between 12-hour and 24-hour modes.

➜The time will be displayed for 5 seconds and then go back to it’s previous status.

19