Leveling Information, Installation, Level The Unit

12Level The Unit

Leveling Information

It is recommended that the unit is level.

13 Install the Unit

Installation

1. Open the water supply valve in the main water source.

1.Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown

2. Plug in the power cord.

CLR2160 & CLRCO2175 Only

•Open the door and press the POWER icon. to turn the unit OFF.

Note: If the unit is NOT turned OFF, water will immediately start flowing into the unit when it is first plugged into the electrical outlet.

•Test the drain system by pouring one gallon of water into the ice bin. The water should drain freely and there should be no leakage.

All Models

2.If the unit is not level, adjust the feet on the corners of the unit as necessary (not available in CO29 models).

Turn Foot to Adjust

3.Check the levelness after each adjustment and repeat the previous steps until the unit is level.

INSTALLATION TIP

If the room floor is higher than the floor in the cut-out opening, adjust the rear feet to achieve a total unit rear height of 1/8" less than the opening’s rear height. Shorten the unit height in the front by adjusting the front feet. This allows the unit to be gently tipped into the opening. Readjust the front feet to level the unit after it is correctly positioned in the opening.

3.Gently push the unit into position. Be careful not to kink the water supply line or entangle the electrical cord.

4.Re-check the leveling, from front to back and side to side. Make any necessary adjustments. The unit’s top surface should be approximately 1/8" below the counter top.

5.Remove the tape from the glass shelves and wipe out the inside of the unit with a clean, water-dampened cloth.

Relocating the Shelves

Both the glass shelves in the refrigerator and the inner door shelves can be moved to accommodate your bottles, cans and containers.

Glass Shelves on Right-Hand Hinge Units

•Open door fully, grasp shelf firmly, lift front edge slightly, and pull straight out.

•Choose new location and slide shelf onto the appropriate rib.

Glass Shelves on Left-Hand Hinge Units

•Pull shelf out about 6” to clear the wall’s molded protrusion.

•Tilt right-hand edge of shelf up.

•Keeping at this angle and hugging the right wall, pull the shelf out.

•Choose new location and insert over ribs, tilting right-hand edge up. Push in, then lower shelf onto ribs.

Door Shelves

•First pull shelf up at a 45° angle, then straight out (see Figure 39).

•Choose new location and line up on bosses. First push straight in, then down at a 45° angle.

Level & Install Unit