U-Line CO2175RF, CO2175FF manual Glass Shelf Removal/Installation, Light Bulb Replacement

Glass Shelf Removal/Installation

Remove the shelves as follows:

ULIN_0213_A

Figure 26

1.Pull shelf out about 6" (Figure 26) until back of shelf clears the “hump” on the right hand side.

2.Tilt right hand edge of shelf up.

3.Remove shelf from unit by pulling out.

Insert the shelves as follows:

1.Insert shelf at an angle, approximately 15-20°, over the rib in the side of the unit where you want to place the shelf. The shelf must be started into the unit at an angle to clear the door.

2.Continue to slide the shelf into the unit at an angle until it clears the door.

3.Lower the shelf and push it in completely.

Light Bulb Replacement

To replace the light bulb in your U-Line unit:

2

1

ULIN_0001_A

Figure 27

1.Grasp the edges of the light housing lens

(Figure 27, 1) opposite the exposed tab and gently push the lens toward the tab (Figure 27, 2).

2.Pull the edge of the lens down (Figure 27, 1) and swing it out of the light housing.

IMPORTANT

ALWAYS use a genuine U-Line replacement bulb (P/N 31317) in the light housing. Use of any other bulb within the housing will generate excessive heat, causing damage to the light housing and cabinet interior, and will compromise the precise temperature control of your unit.

3.Replace the bulb only with a genuine U-Line P/N 31317 replacement.

4.Replace the lens by first inserting the tab side back into the housing at a slight angle. While gently pushing the lens towards the tab end, push the free end up into the housing, and release when you will hear a snap/click.

CO2175FF, 2175RF 17