U-Line CO2175FF manual Interior Lighting, Electronic Control Panel, Temperature Display Selection

Interior Lighting

The LIGHT icon (Figure 3, 5) on the control panel is used to control an additional lighting function. The blackout/ Sabbath mode (not Star K certified) will turn the interior light and display (Figure 3, 3) off.

To access the blackout/Sabbath mode (not Star K certified):

1.Touch and hold the LIGHT icon (Figure 3, 5) for ten seconds and release (the °F symbol will flash briefly at the end of the five second period).

2.The interior light and control display (Figure 3, 3) will go dark for 36 hours.

NOTE: Although the display will not be visible, the temperature controls in the unit remain active, and the interior temperature will be maintained.

3.To exit the blackout/Sabbath mode (not Star K certified) before the 36-hour time period, repeat Step 1.

Electronic Control Panel

1 2 3 4 5

ULIN_0058_A

Figure 5

The electronic control with digital display (Figure 5) is configured to show a single temperature continuously. This set-point temperature is a base number used by the controller to maintain the temperature zone in your unit. The factory default set-point is 38°F. This set-point temperature is used as a gauge if further temperature adjustments are required.

Temperature Display Selection

U-Line products supplied for 110 VAC operation have temperatures displayed in a default Fahrenheit (°F) configuration (Figure 5, 3). Models supplied for 220 VAC operation have temperatures displayed in a default Celsius (°C) configuration.

The display can easily be adjusted for either type of temperature display. Press and hold the LIGHT icon (Figure 5, 5) and within five seconds press the COOLER icon (Figure 5, 4) three times to change the display as desired.

Temperature Display

To display the interior temperature:

1.Touch and hold the WARMER icon (Figure 5, 2) for approximately five seconds and release when the °F symbol in the display (Figure 5, 3) begins to flash.

2.The display (Figure 5, 3) will indicate the actual refrigerator temperature.

3.After approximately 10 seconds, the set-point temperature will return to the display.

Factors which affect the internal temperatures of the cabinet include:

•Temperature setting.

•Ambient temperature where installed.

•Number of times and length of time the door is opened and closed.

•Installation in direct sunlight or near a heat source.

Adjusting Temperature

NOTE: Refrigerator section temperatures are adjustable. Freezer temperatures are not adjustable.

IMPORTANT

Adjust the set-point temperature in single increments, and wait 24 hours for the temperature to stabilize before rechecking.

1 2 3 4 5

ULIN_0058_A

Figure 6

To adjust the set-point temperature:

1.Press and release either the WARMER (Figure 6, 2) or COOLER (Figure 6, 4) icon to put the controller in the SET TEMPERATURE mode. The °F symbol (Figure 6, 3) will begin to flash.

NOTE: If no further action is taken, this mode will self cancel in five seconds, and the original set-point temperature will be displayed.

2.While the °F symbol is flashing, press the WARMER or COOLER icon as required to adjust the set-point temperature.

3.The change will be set five seconds after adjusting the temperature and the new set-point temperature will be displayed.

8 CO2175FF, 2175RF