Maintenance
Leveling
NOTICE
Unit must be level, for proper door and ice maker (if equipped) operation.
1
For Models with adjustable leveling feet:
1.Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1).
2.If the unit is not level, rotate the adjustable leveling legs to raise or lower each corner of the unit as necessary.
3.Check levelness after each adjustment and repeat the previous steps until the unit is level.
For Models without adjustable leveling feet:
NOTICE
The unit must be located on a level surface, for proper door and ice maker (if equipped) operation.
Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1).
Removing and Installing Interior Shelves
1.Pull shelf out about 6" until back of shelf clears the “hump” on the
2.Tilt
up. Remove shelf from unit by pulling out.
Insert the shelves as follows:
1. To move to a different | 2 | |
1 | ||
position in the unit, insert | ||
| ||
shelf at an angle, |
| |
approximately |
| |
the rib in the side of the unit |
| |
where you want to place the |
| |
shelf. The shelf must be |
| |
started into the unit at an |
| |
angle to clear the door. |
|
2.Continue to slide the shelf
into the unit at an angle until free.
3.Lower the shelf and push it in completely.
Light Bulb Replacement
CLRCO2175 Only
To replace the light bulb in your
1.Find the light located at the top of the unit. Grasp the edges of the light housing lens (1), opposite the exposed tab, and gently push the lens toward the tab (2).
2.Pull the edge of the lens down (1) and swing it out of the light housing.
2
1
NOTICE
ALWAYS use a genuine
3.Replace the lens by first inserting the tab side back into the housing at a slight angle.
4.While gently pushing the lens towards the tab end, push the free end into the housing, and release when you hear a snap.
8 |