U-Line U-CLR2160S-41, U-CLR2160SOD-41, U-CLR2160SOD-01 manual Reversing Stainless Steel Glass Doors

Page 15

Remove preexisting bottom hinge.

1.Remove the preexisting bottom hinge (three screws) (2).

Reinstall hinge to top opposite.

1.Install the hinge just removed from the bottom to the TOP opposite side of the cabinet (three screws) (2).

Reinstall Hole Plugs.

1.Install plastic screw plugs (three each, top and bottom) (3) into holes where hinge hardware was removed.

1

NOTCH 5

Prepare door for reinstallation.

1.Remove plastic hole plug from top of door handle and reinstall on opposite side.

2.With bottom of door facing up, remove pivot plate (5) (two screws).

3.Flip over and install pivot plate on opposite side of door. Ensure notch in plate faces center.

Install Door.

1.Hold door upright and tilted forward.

2.Lift door on to bottom hinge closer inserts.

3.Tilt door forward into position.

4.Hold door to keep it from falling.

5.Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver.

Align and adjust the door:

Align and adjust the door, see DOOR ALIGNMENT AND ADJUSTMENT on page 10.

Reversing Stainless Steel Glass Doors

Remove Door

3 1

2

1.Hold door to keep it from falling.

2.Remove hinge screw pin (1) from top hinge using a Phillips screwdriver.

3.Remove door by tilting forward and lifting door off bottom hinge closer inserts.

4.Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver.

Remove hole plugs.

1.Remove plastic screw plugs from (three each, top and bottom)

(3) from new hinge location. Save for reinstallation later.

Remove Stainless Frame

1.Remove two screws from top of door. Save screws for later installation.

Top Of Door

Screws

2.Remove pivot plate from bottom of door by removing 2 screws. Set pivot plate and screws aside for later installation.

Bottom Of Door

Pivot Plate

Screws

12

u-line.com

Image 15
Contents USE and Care Guide Please Record Your Model Information Read and save this Use and Care GuideTable of Contents General Precautions Safety Alert DefinitionsCombo Model Features Model FeaturesInitial Startup Adjusting Air TemperatureTo adjust the set point temperature Air FlowInterior Lighting Checking Product TemperatureClean Alert To check the actual product temperature in the unitTouch Electronic Control Quick GuideForce ice from Evaporator. Damage may Result Clear Ice Maker Cleaning CycleInterval As Required Ice Cube Thickness AdjustmentRefresh Kit Refresh Kit Part Number ModelCLRCO2175 Only Removing and Installing Interior ShelvesLight Bulb Replacement LevelingRemoving and Installing Grille Removing and Installing Door ShelvesInstalling the grille Door Alignment and Adjustment To align and adjust the doorDoor Reversability Remove existing top hinge Reinstall hinge to bottom oppositeReversing Black or White Doors Remove hole plugsReversing Stainless Steel Glass Doors Pull Frame Away Push Glass Remove existing bottom hinge Exterior Cleaning Interior CleaningDefrosting Interval Every Three Months Condenser CleaningStorage, Vacation and Moving Product DisposalTroubleshooting Guide Before Calling for ServiceIf Service is Required Replacement PartsDESIGNED, Engineered and Assembled in WISCONSIN, USA