U-Line 0 U-CLRCO2175B-40, U-CLR2160SOD-41, U-CLR2160SOD-01 manual Remove existing bottom hinge

Page 17

Remove existing bottom hinge.

1.Remove the existing bottom hinge (three screws) (2).

Reinstall hinge to top opposite.

1.Install the hinge just removed from the bottom to the TOP opposite side of the cabinet (three screws) (2).

Reinstall Hole Plugs.

1.Install plastic screw plugs (three each, top and bottom) (3) into holes where hinge hardware was removed.

Install Door.

1.Hold door upright and tilted forward.

2.Lift door on to bottom hinge closer inserts.

3.Tilt door forward into position.

4.Hold door to keep it from falling.

5.Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver.

Align and adjust the door:

Align and adjust the door, see DOOR ALIGNMENT AND ADJUSTMENT on page 10.

14

u-line.com

Image 17
Contents USE and Care Guide Please Record Your Model Information Read and save this Use and Care GuideTable of Contents General Precautions Safety Alert DefinitionsCombo Model Features Model FeaturesTo adjust the set point temperature Adjusting Air TemperatureAir Flow Initial StartupClean Alert Checking Product TemperatureTo check the actual product temperature in the unit Interior LightingTouch Electronic Control Quick GuideForce ice from Evaporator. Damage may Result Clear Ice Maker Cleaning CycleRefresh Kit Ice Cube Thickness AdjustmentRefresh Kit Part Number Model Interval As RequiredLight Bulb Replacement Removing and Installing Interior ShelvesLeveling CLRCO2175 OnlyInstalling the grille Removing and Installing GrilleRemoving and Installing Door Shelves Door Reversability Door Alignment and AdjustmentTo align and adjust the door Reversing Black or White Doors Reinstall hinge to bottom oppositeRemove hole plugs Remove existing top hingeReversing Stainless Steel Glass Doors Pull Frame Away Push Glass Remove existing bottom hinge Defrosting Exterior CleaningInterior Cleaning Storage, Vacation and Moving Condenser CleaningProduct Disposal Interval Every Three MonthsIf Service is Required Before Calling for ServiceReplacement Parts Troubleshooting GuideDESIGNED, Engineered and Assembled in WISCONSIN, USA