U-Line U-CLR2160SOD-40, U-CLR2160SOD-41 manual Door Alignment and Adjustment, Door Reversability

Page 13

Doors (Self-Closing)

Door Alignment and Adjustment

Align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior.

NOTICE

Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gasket to ensure that it is firmly in contact with the cabinet. Also make sure the door gasket is not pinched on the hinge side of the door.

The door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. (3.175 mm) below the cabinet top.

1/8"

(3.175 mm)

To align and adjust the door:

1.Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet and note the type (up or down) of adjustment needed.

1

2 3

1

2 3

2.Remove the top hinge pivot pin with a Phillips screwdriver and lift door off bottom hinge pin. Be careful not to lose the door closer insert sets.

3.Turn the door upside down and inspect the hinge plate mounting holes. The plate has slotted mounting holes. Loosen but do not remove the two hinge plate screws (1).

4.If door edge opposite the hinges needs to move up, move plate toward outside of door (2). If door edge needs to move down, move plate toward inside of door (3). Repeat until top edge of

4

door is parallel with top of cabinet and tighten screws (1) securely.

5.After adjustment is complete, remove the door closers from the bottom hinge, clean thoroughly and apply petroleum jelly to the mating surfaces of the closers. Be sure that pins on closers align with holes in the door and bottom cabinet hinge plates. Mount door and install top hinge pivot pin.

Door Reversability

Location of the unit may make it desirable to mount the door on the opposite side of the cabinet. Many doors are reversible. See table below.

Model

Reverse

Model

Reverse

 

 

 

 

U-2115RB-00

YES

U-2175WCCOL-02

YES

U-2115RS-00

NO

U-2175WCCOL-60

YES

U-2115RS-01

NO

U-2175WCCS-00

YES

U-2115RS-02

NO

U-2175WCCS-02

YES

U-2115RSOD-00

NO

U-2175WCCS-13

YES

U-2115RSOD-01

NO

U-2175WCCS-22

YES

U-2115RW-00

YES

U-CLR2160B-00

YES

U-2115WCOL-00

YES

U-CLR2160B-40

YES

U-2115WCS-00

YES

U-CLR2160S-00

NO

U-2175BEVCOL-00

YES

U-CLR2160S-01

NO

U-2175BEVCOL-02

YES

U-CLR21060S-40

NO

U-2175BEVCOL-60

YES

U-CLR2160S-41

NO

U-2175BEVCS-00

YES

U-CLR2160SOD-00

NO

U-2175BEVCS-02

YES

U-CLR2160SOD-01

NO

U-2175RCB-00

YES

U-CLR2160SOD-40

NO

U-2175RCB-02

YES

U-CLR2160SOD-41

NO

U-2175RCGOL-00

YES

U-CLR2160W-00

YES

U-2175RCGS-00

YES

U-CLR2160W-40

YES

U-2175RCS-00

NO

U-CLRCO2175B-00

YES

U-2175RCS-01

NO

U-CLRCO2175B-40

YES

U-2175RCS-22

NO

U-CLRCO3286S-00

NO

U-2175RCW-00

YES

U-CLRCO2175S-01

NO

U-2175RFB-00

YES

U-CLRCO2175S-40

NO

U-2175RFS-00

NO

U-CLRCO2175S-41

NO

U-2175RFS-01

NO

U-CO2175FB-00

YES

U-2175RFW-00

YES

U-CO2175FS-00

NO

U-2175RSOD-00

NO

U-CO2175FS-01

NO

U-2175RSOD-01

NO

U-CO2175FW-00

YES

U-2175WCCOL-00

YES

 

 

 

 

 

 

10

u-line.com

Image 13
Contents USE and Care Guide Please Record Your Model Information Read and save this Use and Care GuideTable of Contents General Precautions Safety Alert DefinitionsCombo Model Features Model FeaturesTo adjust the set point temperature Adjusting Air TemperatureAir Flow Initial StartupClean Alert Checking Product TemperatureTo check the actual product temperature in the unit Interior LightingTouch Electronic Control Quick GuideForce ice from Evaporator. Damage may Result Clear Ice Maker Cleaning CycleRefresh Kit Ice Cube Thickness AdjustmentRefresh Kit Part Number Model Interval As RequiredLight Bulb Replacement Removing and Installing Interior ShelvesLeveling CLRCO2175 OnlyRemoving and Installing Door Shelves Removing and Installing GrilleInstalling the grille To align and adjust the door Door Alignment and AdjustmentDoor Reversability Reversing Black or White Doors Reinstall hinge to bottom oppositeRemove hole plugs Remove existing top hingeReversing Stainless Steel Glass Doors Pull Frame Away Push Glass Remove existing bottom hinge Interior Cleaning Exterior CleaningDefrosting Storage, Vacation and Moving Condenser CleaningProduct Disposal Interval Every Three MonthsIf Service is Required Before Calling for ServiceReplacement Parts Troubleshooting GuideDESIGNED, Engineered and Assembled in WISCONSIN, USA