Air Flow, Adjusting Air Temperature | U-Line U-CLR2160S-00 instruction

Product Operation

Air Flow

NOTICE

The unit requires proper air flow to perform at its highest efficiency. Do not block the front grille or internal fans at any time, or the unit will not perform as expected. Do not install the unit behind a door.

Adjusting Air Temperature

CLRCO2175

NOTICE

Adjust the set point temperature in single increments, and wait 24 hours for the temperature to stabilize before rechecking.

Initial Startup

All U-Line controls are preset at the factory. Initial startup requires no adjustments.

NOTICE

U-Line recommends allowing the unit to run overnight before loading refrigerator or freezer with product.

To turn the unit on or off, press and hold the POWER icon (1) for about ten seconds and release. The display will show the unit set- point temperature on Combo models, and ICE on Clear Ice models when turned on and display “OFF” when the unit is off.

Electronic Control Panel

Digital Display. The electronic control with digital display on Combo models shows a single continuous set-point temperature, or on Clear Ice models it shows “ICE”. The set point is for the middle zone, it is a base number used by the controller to maintain the multiple temperature zones in the unit. The factory default set- point for Refrigerator models is 38°F. The set-point temperature is a gauge for further temperature adjustments.

Note: The CLRCO2175 refrigerator zone temperature is adjustable. The ice storage bin temperature in the CLRCO2175 or CLR2160 is not adjustable.

To adjust the set point temperature:

1.Press and release either WARMER (2) or COOLER (4) to put the controller in the SET TEMPERATURE mode. The display (3) will begin to flash the °F (or °C) symbol.

NOTE: This mode will self-cancel in five seconds, and the display (3) will show the original set point temperature.

2.Within five seconds (while the °F (or °C) symbol is flashing), press WARMER or COOLER as required to adjust the set point temperature.

3.The change sets five seconds after adjusting the temperature, and the display (3) will show the new set point temperature.

Temperature °F °C Selection. U-Line products supplied for 110 VAC have temperatures displayed (3) by default in Fahrenheit (°F). Models supplied for 220 VAC have temperatures displayed (3) by default in Celsius (°C).

Easily adjust the display for either type temperature display.

1.Press and hold LIGHT (1) and simultaneously within five seconds press COOLER (5) three times to change the display (3) as needed.

Temperature Display. The digital display shows set-point. air temperature. Under normal operating conditions the temperature will fluctuate based on a number of factors including door openings, product load, room temperature, and humidity. The temperature will always be cool toward the top and coolest toward the bottom.

To display actual temperature:

1.Press WARMER (2) for five seconds. The display (3) will indicate the actual temperature.

2.After about 10 seconds, the set point temperature will return to the display.

u-line.com