U-Line ADA15IM manual BI95 & BI98, Door Reversal, Reversing the Door

Page 10

7 Door Reversal

BI95 & BI98

Reversing the Door

All units may be left- or right-hand opening.

Note: The grille should not yet be installed. If it has been installed, remove it for door reversing.

To reverse the door:

1.Remove top hinge from cabinet (three screws). See Figure 1. Hold door to keep it from falling.

2.Lift the door off the bottom hinge.

1

2

3.Remove bottom hinge from cabinet (two screws). See Figure 2. Remove screws on opposite side of cabinet (Figure 3). Note that there may be a nut behind one or both screws on either side.

3

4

4.Install hinge on opposite side, bottom of cabinet. See Figure 4. Replace nut on

back side where installed. Align hinge outer edge with cabinet before tightening screws.

5. Relocate plastic spacer/

 

bushing on bottom of door

 

to opposite side, and place

 

door on bottom hinge pin.

 

See Figure 5. Clean out

5

bushing hole in door bottom

 

with a screwdriver if necessary.

 

6.Remove plastic hole plug from door handle and relocate on opposite side. See Figure 6.

 

Hinge

 

 

Plastic

 

 

Plastic

Plug Hole

 

 

Plug Hole

 

Screw

 

 

Right Side

 

 

Left Side

Door Swing

 

 

Door Swing

Right Side

Invert

Invert

6

Hinge

Screw

Hinge

7.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. See Figure 7.

8.Remove three plastic screw

plugs from hinge holes, top of cabinet, opposite side. Be careful not to scratch

cabinet. See Figure 8.

9. Place door on lower hinge pin. Invert and install upper

hinge on door.

10. Fasten upper hinge to unit (three screws). Partially

tighten screws. See Figure7 9.

11.Adjust door to assure proper seal. Tighten upper and lower

hinge screws securely.

12. Replace three plastic plugs removed in Step 8 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side.

8

U-Line Door Reversal

9

Image 10
Contents Install Guide Table of Contents General Precautions Safety Alert DefinitionsSafety Precautions Tools / Material Required Exterior CleaningProduct Registration Models Covered Inspect & PlanUnits can not be installed behind a closed cabinet door Cut-Out DimensionsPrepare Site BI95BTP ADA15IM Stainless Series BI95B & BI95WH Product DimensionsADA15IM Series BI98 BI2115SP18 SS1095FDSS1095FC SS1095NFWater Supply Door Swing DimensionsPower Supply Environmental RequirementsDoor Reversal BI95 & BI98Reversing the Door 1213 WH95TP, BI95BTP, BCM95 & SP18See Figure 1617Underneath the hinge to the opposite hole in top cap SS10952324 Page Door Panel Installation Panel DimensionsDoor Panel Installation 98, SP18, & ADA15 Door Panel PreparationAdjust Door Adjusting Door AlignmentElectrical Specifications Power SupplyWater Supply Connection PlumbingInstall InstallationGrille Installation Leveling InformationInstallation Troubleshooting BI-2115 SpecificInstallation Guide
Related manuals
Manual 2 pages 62.78 Kb Manual 66 pages 37.32 Kb