WH95TP, BI95BTP, BCM95 & SP18
Reversing The Door
All units may be left- or
1. Remove travel pin from cabinet
(two screws). See Figure 9.
Slide assembly through flange
and set aside to be used later.
2. Remove top hinge from cabinet (three screws). See Figure 10. Hold door to keep it from falling. Slide hinge through flange.
6. Relocate plastic spacer/ |
|
bushing on bottom of door to |
|
opposite side, and place door |
|
on bottom hinge pin. See | Bushing |
Figure 14. Clean out bushing | |
hole in door bottom with a |
|
screwdriver if necessary. |
|
7. Remove plastic travel pin |
|
from door handle and |
|
relocate on opposite side. |
|
See Figure 15. |
|
Hinge
Travel
Pin Hole
14
Travel
Pin Hole
3. Lift the door off the bottom hinge.
4. Remove bottom hinge from
9
| Screw |
|
Right Side |
|
|
Door Swing |
|
|
Right Side | Invert | Invert |
Hinge | Screw | Hinge |
Left Side
Door Swing
15
8.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. See Figure 16.
10 | 11 |
cabinet (two screws). See Figure 11. Remove screws on opposite side of cabinet (Figure 12). Note that there may be a nut behind one or both screws on either side.
1213
5.Install hinge on opposite side, bottom of cabinet. See Figure 13. Replace nut on back side where installed. Align hinge outer edge with cabinet before tightening screws.
1617
9.Gently slide upper hinge through flange and fasten upper hinge to unit (three screws). Partially tighten screws. See Figure 17.
10.Place door on lower hinge pin.
11.Align door pivot hole with
pivot hole in upper hinge and insert pivot screw into upper hinge and tighten securely.
See Figure 18.
12. | Adjust door to assure proper |
|
| seal. Tighten upper and lower |
|
| hinge screws securely. |
|
13. | Gently slide travel pin |
|
| assembly through flange and | 18 |
| then fasten to unit. Make sure | |
|
|
travel pin in door engages the closer in the assembly, then tighten screws on travel pin assembly securely.
10 |