Smeg A3 manual Installation of the Appliance, Positioning and levelling of the appliance

Page 4

Instructions for the installer

2.INSTALLATION OF THE APPLIANCE

It is the law that all gas appliances are installed by competent persons. Corgi gas installers are approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must be in accordance with the gas safety regulations 1984 (installation and use) as amended 1990.

It can be placed against walls higher than the hob, at a distance of at least 50 mm from the side of the appliance, as shown in the drawings A and B relating to the installation classes. Wall units or extractor hoods located above the hob must be at least 750 mm away from it.

A B

SLOT IN

FREE STANDING

2.1 Positioning and levelling of the appliance

This appliance is fitted with 4 castors for easy positioning. To block the appliance in tis final position, extract the feet on the front and screw the corresponding castors in.

CAUTION: delicate floors could be damaged by the castors; in this case, lift the appliance with a mechanical means.

2.2 Electrical connection

Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment.

This rating plate must never be removed.

The connection to the mains shall be done conforming to the regulations in force. Check that the power line is adequately grounded. Do not use reducers, adapters or shunts. On the power line, install an omnipolar cut- off device with contact cut-off distance greater than or equal to 3 mm, located in an easily accessible position near the unit.

42

Image 4

Contents Contents Introduction Instructions for Safe and Proper USEAppliance is Designed for USE by ADULTS. do not Allow Installation of the Appliance Positioning and levelling of the applianceElectrical connection This rating plate must never be removedInstructions for the installer Connecting to natural and LPG gas Ventilation requirementsAdaptation to Different Types of GAS Changing nozzlesBurner and nozzle characteristics table Arrangement of burners on cooking hobLPG G30/G31 28/37 mbar Natural GAS G20 20 mbarFinal Operations Adjustment of minimum for natural gasRegulation of minimum for LPG Mounting the rear top upstand Description of Controls Cooking HOB Burner Command KnobFront control panel Main Oven Thermostat Knob Barbecue Element Power Regulator KnobAuxiliary Oven Variable Grill Knob Auxiliary Oven Thermostat Knob Electronic Programmer Clock adjustmentList of Functions Automatic cooking Semiautomatic cookingEnd of cooking Adjusting alarm volume Switching off the alarmCancellation of set data Minute CounterUSE of the Cooking HOB Lighting of the cooking hob burnersUsing the griddle plate Practical advice for using the cooking hob burnersDiameter of containers Oven Light USE of the OvensStorage compartment Accessories Accessories on Request Function Switch Thermostat Selector Switch from Cooking HintsTraditional cooking main and auxiliary ovens To 250CFunction Switch Thermostat Selector Switch from 50 to 250C Function Switch Thermostat Switch AT MaximumHot-air cooking main oven Grill cooking main ovenHot-air grilling main oven Function Switch Thermostat Switch from 50 to 200CVariable grill cooking auxiliary oven Delicate cooking auxiliary oven Function Switch Thermostat Switch in PositionDefrosting main oven Spit cooking main oven Function Switch Variable Grill Choice Between MIN ¾ MAX Spit cooking auxiliary ovenTraditional Cooking Recommended cooking tableHOT-AIR Cooking Cleaning stainless steel Cleaning and MaintenanceCleaning of cooking hob components Barbecue drip tray GridsSelf-cleaning liners Cleaning of ovens without self-cleaning panelsIgnition plugs and thermocouples Using the self-cleaning liners Looking after the self-cleaning linersAssembling the self-cleaning liners Door glassExtraordinary Maintenance Replacement of light bulbsOven door gaskets Dismantling of the doorsLubrication of gas taps