Smeg DD612S7 manual Annulling a Program

Page 8

User instructions

ANNULLING A PROGRAM

To annul the program in progress, it must first be interrupted (see

INTERRUPTION OF A PROGRAM”).

Now press buttons P1+P2 simultaneously and the first three program lights will come on.

In case that the door is opened during the operation, to the next door closing it is going to be necessary to start the program as shown in paragraph “START PROGRAM”. The program will resume from the point in which it was interrupted.

In case that the tub temperature is higher than 50°C the program will start about 30 seconds later.

The washing cycle will not take place if the dishwasher door is left open or not properly closed.

HALF LOAD WASH FUNCTION (on some models only) (available in all programs except the soak program)

Pressing button ½ LOAD WASH (4) selects washing on the top basket only.

After selecting the program, proceed as follows:

￿press the button ½ LOAD WASH (4) once to select the top basket (the relative light comes on);

￿press the button ½ LOAD WASH (4) again to return to full load wash status (the light goes out).

The ½ LOAD wash option can be selected in all programs except the soak program.

N.B.: selecting the ½ LOAD option changes the duration of the program.

It is possible to place a cutlery basket inside the basket selected for the HALF-LOADprogram; the other basket must remain empty.

WARNING: do not load dishes and cutlery into the non-selected basket, because the water spray will only reach the selected basket.

21

Image 8
Contents Guide for Using the Dishwasher and the Washing Programs Contents Power on Light Phases /PROGRAM LightsON/OFF Button Selection Programs Buttons P1...P5180 120 Lighting ProgrammingSelection Program Start ProgramTo Change a Program END ProgramInterruption of a Program Annulling a Program User instructions User instructions To Save on ENERGY! … and Protect the Environment Removing the DishesAdjusting the Water Softening System Water Hardness TableTroubleshooting Code Phases Lights DescriptionFor Cleaning Dishwashers Contents Safety instructions Safety instructions Aquastop Models Appliance Installation instructions Drain Connection Connecting to the Water SupplyWater supply connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance For Great Britain onlyUsing the water softening system User instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Loading the Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionCleaning the Water Intake Filter Cleaning the Spray ArmsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 135 145