Smeg DD612S7 manual Installation instructions

Page 20

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers.

Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under continuous worktops, and screw them to the adjacent units. To facilitate the installation procedure, the intake and drain hoses can be positioned in any direction; make sure that the hoses are not kinked, crushed or pulled too tightly. Make sure to tighten the locking ring-nut once the pipes have been placed in the direction required. A hole at least 8 cm in diameter is required to allow the power supply cable and pipes to pass.

Level the appliance on the floor using its adjustable feet. This operation is essential for ensuring correct operation of the dishwasher.

Building-in a dishwasher underneath a ceramic hob is absolutely forbidden.

A dishwasher can be built-in underneath a conventional hob provided there is no break in the kitchen worktop, and the dishwasher and hob are installed and secured correctly, so that no hazards are generated.

For free-standing models only

-Installing a hob on top of a free-standing dishwasher is absolutely forbidden.

-If the appliance is not built-in and is therefore accessible on one side, the door hinge area must be covered for safety reasons (injury hazard). The covering fixtures are available as an accessory from specialist dealers or the After-Sales Service.

-To build in the dishwasher, the special kit must be purchased from authorised dealers or the After-Sales Service.

Some models are equipped with only one adjustable foot at the rear, which can be adjusted by turning the screw on the lower front part of the appliance.



Image 20
Contents Guide for Using the Dishwasher and the Washing Programs Contents Power on Light Phases /PROGRAM LightsON/OFF Button Selection Programs Buttons P1...P5180 120 Lighting ProgrammingSelection Program Start ProgramTo Change a Program END ProgramInterruption of a Program Annulling a Program User instructions User instructions To Save on ENERGY! … and Protect the Environment Removing the DishesAdjusting the Water Softening System Water Hardness TableTroubleshooting Code Phases Lights DescriptionFor Cleaning Dishwashers Contents Safety instructions Safety instructions Aquastop Models Appliance Installation instructions Drain Connection Connecting to the Water SupplyWater supply connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance For Great Britain onlyUsing the water softening system User instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Loading the Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionCleaning the Water Intake Filter Cleaning the Spray ArmsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 135 145