20
B. Installing Vent Components
For Model 6000TR
After determining which set of starting collars will be used (top or rear), follow venting instructions accordingly.
Venting Out the Rear Vent
Remove the installed rear seal cap from the rear starting collars by cutting the strap at each end. (See Figure 15). Follow the vent configuration tables accordingly.
Remove the insulation from the REAR five inch flue. Pull the heat shield out from outside of the firebox.
!WARNING: THE TOP HEAT SHIELD (INSIDE THE FIREBOX) MUST REMAIN ATTACHED IF THE VENT SYSTEM IS ATTACHED TO THE REAR STARTING COLLARS. SEE FIGURE 15.
Venting Out the Top Vent
Remove the top vent collar seal cap and the two pieces of insulation inside the top two starting collars (See Figure 15). Next remove the glass door.
Remove the heat shield from inside the TOP five inch flue from outside of the firebox.
You have to take the glass off again for positioning the logs when the unit is finally installed in place and finished around it. Reinstall the glass door. Attach vent system to the top starting collars.
!WARNING: THE REAR VENT COLLAR SEAL CAP MUST REMAIN ATTACHED TO THE REAR VENT COLLARS IF THE VENT SYS- TEM IS ATTACHED TO THE TOP STARTING COLLARS. SEE FIGURE 15.
!WARNING: FAILURE TO REMOVE INSULA- TION IN THE SET OF COLLARS YOU ARE USING COULD CAUSE A FIRE.
!WARNING: YOU MUST LEAVE THE INSU- LATION IN PLACE IN THE SET OF COL- LARS YOU ARE NOT USING.
