Heat & Glo LifeStyle 6000XLS, 6000XLT-CDN, 6000TR Positioning the Logs, Placing the Ember Material

38

Positioning the Logs

If the gas logs have been factory installed they should not need to be positioned.

If the logs have been packaged separately, refer to the installation instructions that accompany the logs. Save the log instructions with this manual.

If sooting occurs, the logs might need to be repositioned slightly to avoid excessive flame impingement.

Placing the Ember Material

Two separate bags of ember material are shipped with this gas fireplace:

•The bag labeled Golden Ember (GE-93) is flame colorant material.

•The bag labeled Glowing Ember (050-721) is standard glowing ember material.

To place the ember material:

•Turn the tension springs around the glass door 90°.

•Remove the glass door from the unit.

•NOTE: FOR MODEL 6000ARCH ONLY. Remove wing nuts and glass clips. Pull glass out from bottom and pull downward.

•Cover the top of the burner with a single layer of ember material. Then sprinkle GE-93 on top of the burner.

•Save the remaining ember materials for use during fireplace servicing.

•Replace the glass door and a front trim door on the unit (see Replacement Parts Section of the manual.)

•Pull out and twist the tension springs 90° to lock.