Heat & Glo LifeStyle 6000XLT-CDN, 6000TR, 6000XLS Step The Gas Supply Line, Gas Controls Systems

STANDING PILOT	NOTE: FLAMES TOO	DSI IGNITION
	CLOSE TO THE
	CERAMIC INSULATORS
	CAN CAUSE NUISANCE
	LOCKOUTS AND
	ELECTRODE FAILURE.	IGNITOR
		3/8” (10mm)
	CERAMIC
	INSULATOR
	1/4" (6mm)

Figure 29. Gas Controls Systems

32

Step 6

The Gas

Supply Line

NOTE: Have the gas supply line installed by a qualified service technician in accordance with all building codes.

NOTE: Before the first firing of the fireplace, the gas supply line should be purged of any trapped air.

NOTE: Consult local building codes to properly size the gas supply line leading to the 1/2 inch (13 mm) hook-up at the unit.

This gas fireplace is designed to accept a 1/2 inch

(13 mm) gas supply line. To install the gas supply line:

•A listed 1/2 inch (13 mm) manual shut-off valve and a listed flexible gas connector are connected to the 1/2 inch (13 mm) inlet of the control valve.

•The gas line may be run from either side of the fireplace provided the hole in the outer wrap does not exceed 2 inches in diameter and it does not penetrate the airtight box.

•The gap between the supply piping and gas ac- cess hole can be plugged with non-combustible insulation to prevent cold air infiltration.

•Locate the gas line access hole in the outer casing of the fireplace.

•Open the fireplace lower grille, insert the gas sup- ply line through the gas line hole, and connect it to the shut-off valve.

•When attaching the pipe, support the control so that the lines are not bent or torn.

•After the gas line installation is complete, use a soap solution to carefully check all gas connections for leaks.

!WARNING: DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.