Smeg CA01-3 instruction manual Safety instructions, Safety and operating instructions

Page 11

Safety instructions

1. Safety and operating instructions

THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL.

INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE EEC DIRECTIVES 72/23, 89/336 (INCLUDING 92/31) CURRENTLY IN FORCE, INCLUDING THE PREVENTION AND ELIMINATION OF RADIO FREQUENCY INTERFERENCE.

THE APPLIANCE IS DESIGNED FOR THE FOLLOWING PURPOSE: WASHING AND DRYING OF DISHES; ANY OTHER USE SHALL BE CONSIDERED IMPROPER. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR

USES OTHER THAN THOSE DESCRIBED ABOVE.

THE NAME PLATE FEATURING THE TECHNICAL DATA, SERIAL NUMBER AND MARKINGS IS VISIBLY POSITIONED ON THE INNER EDGE OF THE DOOR. THE NAME PLATE ON THE INNER EDGE OF THE DOOR MUST

NEVER BE REMOVED.

DO NOT LEAVE THE DISCARDED PACKAGING MATERIALS UNSUPERVISED WITHIN THE HOME. SEPARATE THE VARIOUS MATERIALS WHICH MAKE UP THE PACKAGING AND TAKE THEM TO THE NEAREST SORTED WASTE COLLECTION CENTRE.

THE APPLIANCE MUST BE PROVIDED WITH AN EARTH CONNECTION IN ACCORDANCE WITH THE ELECTRICAL SAFETY REGULATIONS IN FORCE.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE FAILURE TO EARTH THE APPLIANCE OR FROM A DEFECTIVE EARTH CONNECTION.

IF THE APPLIANCE IS INSTALLED ON A CARPETED OR COVERED FLOOR, ENSURE THAT THE OPENINGS ON ITS UNDERSIDE ARE NOT OBSTRUCTED.

ALWAYS SWITCH OFF THE DISHWASHER AFTER EACH USE TO AVOID WASTING ELECTRICITY.

OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGING IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.).



Page 10 Page 12
Image 11
Page 10 Page 12
Contents For Cleaning Dishwashers Contents Front panel Setting the Washing ProgramDescription of the controls Table of Programs Correct amount of detergent has been added to the dispenser Cancelling the Current ProgramWashing programs Before starting a washing program make sure thatTo Save on ENERGY! … and Protect the Environment Removing the Dishes END of CycleWater Hardness Table Adjusting the Water Softening SystemFor Cleaning Dishwashers Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models For free-standing models only Installation and hook-upDrain Connection Connecting to the Water SupplyWater supply connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsFor Great Britain only When Cleaning and Maintaining the ApplianceOperating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendationsUser instructions EN 50242 Standard Loads for Certification Bodies Using the basketsLoading the Lower Basket Lower BasketUpper Basket Cutlery BasketLoading the Upper Basket Version B Adjusting the Upper BasketUser instructions Cleaning the Spray Arms Cleaning and maintenanceCleaning the Water Intake Filter Fill the rinse aid dispenser Shut off the water supply tap Cleaning the Filter UnitIf water remains inside the dishwasher, check that If the dishes are not being cleaned properly, check thatReconnect the water intake hose and open the tap again If the program fails to start, check thatIf there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check that135 145
Top Page Image Contents