Smeg CA01-3 instruction manual Electrical connection and precautions

Page 16

Installation instructions

2.2 Electrical connection and precautions

CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR.

THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE.

THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION.

NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD.

IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT REPLACED BY THE MANUFACTURER OR AN AUTHORIZED TECHNICAL SERVICE CENTRE.

DO NOT USE ADAPTORS OR SHUNT CONNECTIONS IN ORDER TO AVOID

THE POSSIBILITY OF OVERHEATING OR BURNING.

IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD:

IT IS NECESSARY TO INSTALL IN THE FIXED WIRING AN ALL-POLE DISCONNECTION DEVICE HAVING A GAP BETWEEN CONTACTS OF AT LEAST 3.5MM. AFTER INSTALLATION THE DISCONNECTION DEVICE HAS TO BE EASY TO REACH.

THE CONNECTION TO THE MAINS MUST BE CARRIED OUT BY A QUALIFIED TECHNICIAN IN ACCORDANCE TO THE SCHEME SHOWN BELOW AND THE REGULATIONS IN FORCE.

L = brown N = blue

= yellow-green

In the event of damage to the supply cord, have it replaced by the manufacturer or an Authorized Technical Service Centre in order to avoid any risk.

Image 16

Contents For Cleaning Dishwashers Contents Description of the controls Setting the Washing ProgramFront panel Table of Programs Cancelling the Current Program Washing programsBefore starting a washing program make sure that Correct amount of detergent has been added to the dispenserTo Save on ENERGY! … and Protect the Environment END of Cycle Removing the DishesAdjusting the Water Softening System Water Hardness TableFor Cleaning Dishwashers Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up For free-standing models onlyWater supply connection Connecting to the Water SupplyDrain Connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance For Great Britain onlyUsing the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent General warnings and recommendations ProductsUser instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Loading the Lower BasketCutlery Basket Upper BasketLoading the Upper Basket Adjusting the Upper Basket Version BUser instructions Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Cleaning the Filter Unit Fill the rinse aid dispenser Shut off the water supply tapIf the dishes are not being cleaned properly, check that Reconnect the water intake hose and open the tap againIf the program fails to start, check that If water remains inside the dishwasher, check thatIf the dishes fail to dry or remain dull, check that If there are visible traces of rust inside the tank135 145