Smeg CA01-3 instruction manual When Cleaning and Maintaining the Appliance, For Great Britain only

Page 17

Installation instructions

WHEN CLEANING AND MAINTAINING THE APPLIANCE:

BEFORE CARRYING OUT ANY WORK, ALWAYS UNPLUG THE APPLIANCE FROM THE ELECTRICAL SUPPLY OR SWITCH OFF THE ALL-POLE DISCONNECTION DEVICE.

FOR GREAT BRITAIN ONLY:

THIS APPLIANCE MUST BE EARTHED.

Fuse replacement

If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows:

1.Remove the fuse cover A and fuse B.

2.Fit replacement 13A fuse into fuse cover.

3.Refit both into plug.

The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted.

Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug.

Replacement fuse covers are available from your local electrical store.

Image 17

Contents For Cleaning Dishwashers Contents Front panel Setting the Washing ProgramDescription of the controls Table of Programs Washing programs Cancelling the Current ProgramBefore starting a washing program make sure that Correct amount of detergent has been added to the dispenserTo Save on ENERGY! … and Protect the Environment Removing the Dishes END of CycleWater Hardness Table Adjusting the Water Softening SystemFor Cleaning Dishwashers Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models For free-standing models only Installation and hook-upDrain Connection Connecting to the Water SupplyWater supply connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsFor Great Britain only When Cleaning and Maintaining the ApplianceOperating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendationsUser instructions EN 50242 Standard Loads for Certification Bodies Using the basketsLoading the Lower Basket Lower BasketUpper Basket Cutlery BasketLoading the Upper Basket Version B Adjusting the Upper BasketUser instructions Cleaning the Spray Arms Cleaning and maintenanceCleaning the Water Intake Filter Fill the rinse aid dispenser Shut off the water supply tap Cleaning the Filter UnitReconnect the water intake hose and open the tap again If the dishes are not being cleaned properly, check thatIf the program fails to start, check that If water remains inside the dishwasher, check thatIf there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check that135 145