Smeg CA01-3 instruction manual Reconnect the water intake hose and open the tap again

Page 32

User instructions

BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:

•Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes.

•Plug the power cord back into the socket.

•Reconnect the water intake hose and open the tap again.

TROUBLESHOOTING MINOR PROBLEMS

In some cases it is possible to remedy minor problems by referring to the following instructions:

If the program fails to start, check that:

•the dishwasher is connected to the electrical power supply;

•there is no power failure;

•the water tap is open;

•the dishwasher door is properly closed.

If water remains inside the dishwasher, check that:

•the drain hose is not kinked;

•the drain siphon is not obstructed;

•the dishwasher filters are not clogged.

If the dishes are not being cleaned properly, check that:

•the correct amount of detergent has been added;

•there is regenerating salt inside the special container;

•the dishes are being loaded correctly;

•the selected program is suitable for the dish types and their degree of soiling;

•all the filters are clean and positioned correctly;

•the spray arm nozzles are not obstructed;

•there is no object obstructing the rotation of the spray arms.

49

Image 32

Contents For Cleaning Dishwashers Contents Front panel Setting the Washing ProgramDescription of the controls Table of Programs Cancelling the Current Program Washing programsBefore starting a washing program make sure that Correct amount of detergent has been added to the dispenserTo Save on ENERGY! … and Protect the Environment END of Cycle Removing the DishesAdjusting the Water Softening System Water Hardness TableFor Cleaning Dishwashers Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up For free-standing models onlyDrain Connection Connecting to the Water SupplyWater supply connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance For Great Britain onlyUsing the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent General warnings and recommendations ProductsUser instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Loading the Lower BasketCutlery Basket Upper BasketLoading the Upper Basket Adjusting the Upper Basket Version BUser instructions Cleaning the Spray Arms Cleaning and maintenanceCleaning the Water Intake Filter Cleaning the Filter Unit Fill the rinse aid dispenser Shut off the water supply tapIf the dishes are not being cleaned properly, check that Reconnect the water intake hose and open the tap againIf the program fails to start, check that If water remains inside the dishwasher, check thatIf the dishes fail to dry or remain dull, check that If there are visible traces of rust inside the tank135 145