Smeg S108X-5 manual Instructions for the installer, Installation, Electrical connection

Page 4

Instructions for the installer

Instructions for the installer

2. INSTALLATION

2.1 Electrical connection

Check that the mains voltage and power cable ratings are as per the information provided on the label attached to the oven door frame.

This label must never be removed.

It is obligatory for the electrical system to be earthed according to the methods required by safety rules.

If a plug and socket connection is being used make sure that the plug and socket are compatible. Avoid use of adapters and shunts as these could cause overheating and risk of burns.

If a fixed connection is being used fit cable line with an omnipolar circuit breaker with a contact opening gap equal to or greater than 3 mm in an easily accessible position in proximity to the oven.

For operation on 220-240V ∼: use an

H05RR-F / H05RN-F type three-core cable (3 x 1.5 mm2).

The cable end to be connected to the appliance must be provided with an ground wire (yellow-green) at least 20 mm longer.

2.1.1 Ovens with hob controls

In the ovens with hob controls the power cable is not supplied. Use a H05RR-F or H05RN-F rubber-sheathed cable making sure that it does not come into contact with any external metal parts of the oven when routing.

Remove rear cover by loosening relevant screws to gain access to the terminal strip. If necessary change jumper configuration as shown in the diagram and then connect wires making sure that the earth wire is at least 20 mm longer than the others. Secure power cable to oven by means of an appropriate fitting.

30

Image 4

Contents Contents 1. INSTRUCTIONS FOR SAFE AND PROPER USE 2. INSTALLATION5. AVAILABLE ACCESSORIES 6. COOKING HINTS 7. CLEANING AND MAINTENANCE 8. ADDITIONAL MAINTENANCEIntroduction 1. INSTRUCTIONS FOR SAFE AND PROPER USETHE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE NEVER UNPLUG BY PULLING ON THE CABLETHE PLATE MUST NOT BE REMOVED Instructions for the installer 2. INSTALLATION2.1 Electrical connection This label must never be removedH05RR-F / H05RN-F type three-core cable 3 x 4 mm2 For operation on 380-415V2N∼ use anH05RR-F / H05RN-F type four-core cable 4 x 2.5 mm2 For operation on 380-415V3N∼ use an2.2 Installing the oven Never use the oven door to lever the oven into place when fitting 2.3 Connecting the hob to the ovenAvoid exerting too much pressure on the oven door when open Instructions for the user 3. DESCRIPTION OF CONTROLS3.1 Front control panel FUNCTION CONTROL KNOBHOB CONTROL KNOB PILOT LIGHT GREENHOB CONTROL KNOB WITH DUAL ZONES 3.2 Electronic Analogue Clock 3.2.1 Setting the timeLIST OF FUNCTIONS 3.2.2 Minute-minder 3.2.3 Programming Caution cooking times of more than 6 hours cannot be set3.2.4 DEMO Function 4.1 Warnings and general advice 4. USE OF THE OVEN4.2 Cooling system 4.3 Oven lightSome models do not feature all accessories 5. AVAILABLE ACCESSORIESAccessories available on request FUNCTION SWITCH THERMOSTAT SWITCH FUNCTION SWITCHTHERMOSTAT SWITCH 6. COOKING HINTS6.4 Fan grilling multifunction models 6.3 Grill cookingGrill function must be used only with the door closed 6.5 Delicate cooking in some models only FUNCTION SWITCH THERMOSTAT SWITCH IN POSITION6.6 Defrosting multifunction models TRADITIONAL COOKING GRILLING6.7 Recommended cooking table FIRST COURSESFAN COOKING 7. CLEANING AND MAINTENANCE 7.1 Cleaning stainless steel7.2 Cleaning of the oven without self-cleaning panels 7.1.1 Ordinary Daily Cleaning7.3 Self-cleaning liners only on some models 7.3.1 Using the self-cleaning liners7.3.2 Looking after the self-cleaning liners 7.3.3 Assembling the self-cleaning liners8. ADDITIONAL MAINTENANCE 8.1 Replacement of light bulbBefore any intervention, disconnect the power supply Only use oven bulbs T 300C8.2 Removing the door 8.3 Oven door seal