Smeg SA561X-9 Installing the Appliance, Electrical connection, Cable replacement

Page 47

Instructions for the User

10.INSTALLING THE APPLIANCE

10.1 Electrical connection

The identification plate bearing the technical data, serial number and brand name is visibly positioned on the appliance.

Do not remove this plate for any reason.

The appliance must be connected to earth in compliance with electrical system safety regulations.

If a fixed connection is being used, fit the power line with an omnipolar circuit- breaker in accordance with the installation rules, located in a position which is easy to reach and near the appliance.

If a plug and socket connection is being used, make sure that the plug and socket are compatible. Avoid use of adapters and shunts as these could cause overheating and a risk of burns.

Operation at 220-240 V~: use a H05V2V2-F type three-core cable (3 x 1.5 mm2).

The end to be connected to the appliance must have an earth wire (yellow-green) at least 20 mm longer than the others.

WARNING: The values indicated above refer to the cross-section of the internal conductor.

10.2 Cable replacement

Should the supply cable need replacing, remove the back guard by unscrewing the screws to gain access to the terminal.

Replace the cable. The cable cross- section must be no less than 1.5 mm² (3 x 1.5) (see 10.1 Electrical connection).

Make sure that the cables (for the oven or any hob) follow the best route in order to avoid any contact with the oven.

WARNING: The tightening torque of the screws of the terminal supply wires

must be 1.5 - 2 Nm.

48

Image 47
Contents SA561X-9 Contents Instructions for USE General instructionsGeneral instructions Safety Precautions General instructions Environmental Responsibility Instructions for disposalMultifunction Pyrolytic GET to Know Your OvenSome models are not provided with all Available AccessoriesMechanical lock must always face the back of the oven Using the rack or trayUsing the support rack Using the handle Using the rotisserie rod on some models only Ovens with frames Ovens with runners Using the OvenGeneral Description Oven runners Oven inside lights Cooling systemInstructions for the User Oven Thermostat Knob Description of the controls on the front panelInstructions for the User Instructions for the User Function Knob Electronic programmer on some models only Setting the timeUsing the timer Automatic cooking Stopping the buzzerSemi-automatic cooking Modifying the set data Adjusting the buzzer volumeEnd of semi-automatic / automatic cooking Deleting the set dataECO Cooking with the OvenFAN-ASSISTED Grill Advice for defrosting and proving Cooking advice and instructionsAdvice for cooking meat Advice for cooking desserts and biscuitsTo save energy Advice for cooking with the Grill and the Fan-assisted grillMeat Cooking process information table1ST Surface 2ND Surface Pizza 280 190 180 160 170 150 Proving Quantity Proving and defrosting functionsOn pyrolytic models only Cleaning the door glazing Cleaning and MaintenanceCleaning stainless steel Ordinary daily cleaningCleaning the inside of the oven Ovens with runners Removing guide frames Pyrolysis automatic oven cleaning on some models only Cleaning Light Dirt Medium Dirt Heavy Dirt Duration Before starting the automatic cleaning cycleTo select a cleaning cycle with a delayed start Setting the cleaning cycleBefore starting the assisted cleaning cycle Vapor Clean assisted oven cleaning on some models onlySetting the assisted cleaning cycle End of the assisted cleaning cycle Directly with your fingers, wrap them Extraordinary MaintenanceReplacing the light bulb On some models only the bulbs areWith moveable levers Removing the doorWith pins For multifunction models only Removing the door sealRemoving the internal glass panels Multifunction models CleaningRemoving the internal glass panel Removing the middle glass panels pyrolytic modelsDo not remove this plate for any reason Installing the ApplianceCable replacement Electrical connectionPositioning the oven Measurements Instructions for the installerInstructions for the installer Page Page 914773682/ B