Smeg SA561X-9 installation instructions Instructions for the installer, Measurements

Page 49

Instructions for the installer

When installing in tall units, comply with the dimensions shown in figures 1 and 2, bearing in mind that the top/rear of the unit must have an opening 35-40 mm deep.

Remove the screw covers on the frame and screw in the 2 screws A (fig. 5) to fix the appliance to the unit. Replace the screw covers. For installing beneath a countertop hob, allow for a rear and bottom clearance as shown in Figure 1 (ref. F).

See the relevant instructions for fitting and securing the appliance.

FIG.1

Measurements

(mm)

50

A

583 ÷ 585

B

554 ÷ 564

C

490 ÷ 500

D

560 min.

E

35 ÷ 40

Image 49
Contents SA561X-9 Contents Instructions for USE General instructionsGeneral instructions Safety Precautions General instructions Environmental Responsibility Instructions for disposalMultifunction Pyrolytic GET to Know Your OvenSome models are not provided with all Available AccessoriesUsing the support rack Using the rack or trayMechanical lock must always face the back of the oven Using the handle Using the rotisserie rod on some models only General Description Oven runners Using the OvenOvens with frames Ovens with runners Oven inside lights Cooling systemInstructions for the User Oven Thermostat Knob Description of the controls on the front panelInstructions for the User Instructions for the User Function Knob Using the timer Setting the timeElectronic programmer on some models only Semi-automatic cooking Stopping the buzzerAutomatic cooking End of semi-automatic / automatic cooking Adjusting the buzzer volumeDeleting the set data Modifying the set dataECO Cooking with the OvenFAN-ASSISTED Grill Advice for cooking meat Cooking advice and instructionsAdvice for cooking desserts and biscuits Advice for defrosting and provingTo save energy Advice for cooking with the Grill and the Fan-assisted grillMeat Cooking process information table1ST Surface 2ND Surface Pizza 280 190 180 160 170 150 On pyrolytic models only Proving and defrosting functionsProving Quantity Cleaning stainless steel Cleaning and MaintenanceOrdinary daily cleaning Cleaning the door glazingCleaning the inside of the oven Ovens with runners Removing guide frames Pyrolysis automatic oven cleaning on some models only Cleaning Light Dirt Medium Dirt Heavy Dirt Duration Before starting the automatic cleaning cycleTo select a cleaning cycle with a delayed start Setting the cleaning cycleBefore starting the assisted cleaning cycle Vapor Clean assisted oven cleaning on some models onlySetting the assisted cleaning cycle End of the assisted cleaning cycle Replacing the light bulb Extraordinary MaintenanceOn some models only the bulbs are Directly with your fingers, wrap themWith moveable levers Removing the doorWith pins Removing the internal glass panels Removing the door sealFor multifunction models only Removing the internal glass panel CleaningRemoving the middle glass panels pyrolytic models Multifunction modelsCable replacement Installing the ApplianceElectrical connection Do not remove this plate for any reasonPositioning the oven Measurements Instructions for the installerInstructions for the installer Page Page 914773682/ B