Andrew ATC200-Lite manual Setup Introduction Screen

Page 16

Section 2–Program Installation

ATC200-Lite Teletilt® Remote Control Downtilt System

Figure 2-3. Setup Introduction Screen.

Figure 2-4. Installation Settings Screen.

2-

May 2005

Bulletin 639510

Image 16

Contents Andrew Corporation Base Station Antennas Telecom Parkway Richardson, Texas Tel 214 Fax 214Page Revision History Revision No Date Description of Changes None May ReleasedATC200-Lite Teletilt Remote Control Downtilt System Iii ESD Wrist Strap ATC200-Lite Teletilt Remote Control Downtilt System This page intentionally left blank Contents Part Numbering Scheme and Ordering Guide 10-1 Controller Setup ATC200-Lite Series Controller SetupSystem Description ATC200-Lite Series Controller CommunicationATC200-Lite Controller with RS-232 Serial Cable Attached Example of ATC200 System Diagram This page intentionally left blank Program Installation Program Download and InstallationSetup Introduction Screen Software Upgrades and Antenna Definition File Updates Completing Setup ScreenMay Bulletin Program Startup and Configuration Preparing for Program StartupSerial Port Selection at Program Startup ATC200-Lite Application IconSelecting a Serial Port Beginning Program Operation Antenna Definition File SelectionSelecting ‘Antenna Files’ from Main Menu This page intentionally left blank Device Discovery and Addressing Device SearchClick ‘OK’ Bulletin May Addressing Click ‘Remove Device’Confirmation of Device Removal 10. Assigning a New Address 13. Closing ‘Manual Addressing’ Screen This page intentionally left blank Device Configuration Selecting Device to be ConfiguredMake appropriate selections and text entries Bulletin May If satisfied with new configuration data, click ‘Yes’ Bulletin May This page intentionally left blank Selecting Device for Electrical Downtilt Adjustment Changing the Electrical Downtilt on a Single AntennaClick ‘Activate’ Enter a new electrical tilt angle Click ‘OK’ May Bulletin Changing the Electrical Downtilt on a Group of Antennas Selecting an Antenna Within a SectorAdding Devices to be Included in the Sector Move Entering New Electrical Tilt Setting for Sector Move Click ‘OK’ Saving a Site Report or Site Configurations Saving/Viewing a Site Report Formatted to Open in WordClick ‘Save’ Assign a filename to the report Select the ‘txtrpt’ file Go to ‘ATC200SiteFiles’ directory Report File Opened in Word Saving/Viewing a Site Report Formatted to Open in Excel Selecting the File Format for ExcelSelect the ‘tabrpt’ file Go to ‘ATC200SiteFiles’ directory Report File Opened in Excel Saving Configurations for Future Use Saving Site Configurations to Hard Drive for Future UseDevice Test, Alarm Status and Device Information Device Status and Test OptionsRetrieving Current Alarm Status Obtaining Device InformationClearing All Alarms on a Device Executing a Self Test Movement for a DeviceSelf Test Results Part Numbering Scheme and Ordering Guide Part Numbering SchemeOrdering Guide Quantity Part Number DescriptionControl System Specifications ElectricalThis page intentionally left blank Bulletin Bulletin Appendix B Antennas For ATC200-Lite Series SystemThis page intentionally left blank