Andrew ATC200-Lite manual If satisfied with new configuration data, click ‘Yes’

Section 5–Device Configuration ATC200-Lite Teletilt® Remote Control Downtilt System

Alternately, the suggested date may be erased and a new date entered, or the field may be left blank. When a date is entered, it must be formatted as shown in Figure 5-2 (A ‘forward slash’ character placed between the month and day and a ‘forward slash’ character placed between the day and year). i.e., August 4, 2004 would be typed as 08/04/04.

•The installer’s ID must be 1 to 5 characters in length with any combination of letters and numbers.

•Values specified for the frequency band, sector, technology, location, and mechani- cal tilt are used for reference only and have no direct affect upon the actuator/ antenna that is being configured.

8.Carefully review all selections. If satisfied that all are correct, click ‘Configure’. Alternately, the user may go back and edit/change any of the selections made or click the ‘Cancel’ button to quit this process without making any changes to the actuator’s current configuration.

9.After the ‘Configure’ button has been activated, the user will be prompted to confirm the desire to make these changes to the actuator. Click ‘Yes’ to proceed with the changes, or click ‘No’ to return to the configuration screen (Figure 5-3).

When proceeding to make changes, the settings selected will be sent to the actuator. The main screen will change the status of this device to ‘Configuring’ to indicate that new set- tings are being sent to the actuator.

10.When the configuration process is complete, a pop-up dialog box will display the results. Normally, the dialog box will show that the changes were successfully sent to the device (Figure 5-4). However, if the configuration process was unable to communicate with the actuator for any reason, a failure message will appear.

If satisfied with new configuration data, click ‘Yes’.

Figure 5-3. Choosing to Continue with Configuration Changes to the Device.

Click ‘OK’.

Figure 5-4. Confirmation of Configuration Changes to Device.

5- May 2005 Bulletin 639510