Andrew ATC200-Lite manual Bulletin May

Page 37

ATC200-Lite Teletilt® Remote Control Downtilt System

Section 5–Device Configuration

If this occurs, ensure that all cables and connectors to the actuator are properly connected, and that the system is still properly powered up. Also, verify that the actuator is present in the ‘Device Information’ list, and that it does not have a status reading of ‘Not Reporting’. A status of ‘Not Reporting’ indicates that connectivity to the actuator has been lost. After verifying that each of these items are correct, repeat the configuration process.

11.Click ‘OK’ (Figure 5-4) to dismiss the pop-up dialog box. The main screen will display the results of the device configuration.

12.Note that not all of the items that were configured are displayed on the main screen. To verify that each of the items configured were set correctly, select the device in the ‘Device Information’ list and click ‘Edit Selected’ to review each item. Click the ‘Cancel’ button on the ‘Device Configuration’ screen when finished with verification.

Bulletin 639510

May 2005

5-

Image 37

Contents Telecom Parkway Richardson, Texas Tel 214 Fax 214 Andrew Corporation Base Station AntennasPage Revision No Date Description of Changes None May Released Revision HistoryATC200-Lite Teletilt Remote Control Downtilt System Iii ESD Wrist Strap ATC200-Lite Teletilt Remote Control Downtilt System This page intentionally left blank Contents Part Numbering Scheme and Ordering Guide 10-1 ATC200-Lite Series Controller Setup Controller SetupSystem Description ATC200-Lite Series Controller CommunicationATC200-Lite Controller with RS-232 Serial Cable Attached Example of ATC200 System Diagram This page intentionally left blank Program Download and Installation Program InstallationSetup Introduction Screen Completing Setup Screen Software Upgrades and Antenna Definition File UpdatesMay Bulletin Preparing for Program Startup Program Startup and ConfigurationATC200-Lite Application Icon Serial Port Selection at Program StartupSelecting a Serial Port Antenna Definition File Selection Beginning Program OperationSelecting ‘Antenna Files’ from Main Menu This page intentionally left blank Device Search Device Discovery and AddressingClick ‘OK’ Bulletin May Click ‘Remove Device’ AddressingConfirmation of Device Removal 10. Assigning a New Address 13. Closing ‘Manual Addressing’ Screen This page intentionally left blank Selecting Device to be Configured Device ConfigurationMake appropriate selections and text entries Bulletin May If satisfied with new configuration data, click ‘Yes’ Bulletin May This page intentionally left blank Changing the Electrical Downtilt on a Single Antenna Selecting Device for Electrical Downtilt AdjustmentClick ‘Activate’ Enter a new electrical tilt angle Click ‘OK’ May Bulletin Selecting an Antenna Within a Sector Changing the Electrical Downtilt on a Group of AntennasAdding Devices to be Included in the Sector Move Entering New Electrical Tilt Setting for Sector Move Click ‘OK’ Saving/Viewing a Site Report Formatted to Open in Word Saving a Site Report or Site ConfigurationsClick ‘Save’ Assign a filename to the report Select the ‘txtrpt’ file Go to ‘ATC200SiteFiles’ directory Report File Opened in Word Selecting the File Format for Excel Saving/Viewing a Site Report Formatted to Open in ExcelSelect the ‘tabrpt’ file Go to ‘ATC200SiteFiles’ directory Report File Opened in Excel Saving Site Configurations to Hard Drive for Future Use Saving Configurations for Future UseDevice Status and Test Options Device Test, Alarm Status and Device InformationObtaining Device Information Retrieving Current Alarm StatusExecuting a Self Test Movement for a Device Clearing All Alarms on a DeviceSelf Test Results Part Numbering Scheme Part Numbering Scheme and Ordering GuideQuantity Part Number Description Ordering GuideElectrical Control System SpecificationsThis page intentionally left blank Bulletin Bulletin Antennas For ATC200-Lite Series System Appendix BThis page intentionally left blank